Notices

Repainting outboard bracket

Old 10-04-2019, 06:10 PM
  #1  
Senior MemberCaptains Club Member
Thread Starter
 
Join Date: Sep 2007
Posts: 238
Default Repainting outboard bracket

Need to refinish the outboard bracket on the boat (12 years old). It's starting loosen up and bubble up in spots.
What do I do to prep it and what kind of paint?
pectoralfin1 is offline  
Old 10-06-2019, 07:01 AM
  #2  
Senior Member
 
Join Date: Jun 2017
Posts: 613
Default

I bought an unpainted bracket from d&d marine & a guy at my job that's also paints on the side put an epoxy primer & then 2 coats of what he called comerccial epoxy paint is holding up good so far. was not awl grip or emron. but I think DuPont made it
Timex is offline  
Old 10-06-2019, 07:09 AM
  #3  
HTJ
Senior Member
 
Join Date: Jun 2013
Location: Baytown, TX
Posts: 10,326
Default

If the paint is failing to the point that you think 100% removal is the answer - the important thing is what you do afterwards. Once the paint is off I would give it a good scrubbing with simple green or the like, give the while thing a once over with 220 on an orbital and then another bath. Prime with an etch primer and follow the directions on the can - is normally a minimum of 12 hours before you can topcoat. And speaking of topcoats a single stage urethane is avery good answer - easy to apply, durable and affordable.

Good luck
HTJ is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread