Notices
 
Search: Posts Made By: flukin nuts
Showing results 1 to 25 of 303
Search took 0.23 seconds.
06-03-2019, 06:42 PM
Replies: 26
Views: 1,203
Posted By flukin nuts

Lay an ice cube on it to shrink it a bit. Then a...

Lay an ice cube on it to shrink it a bit. Then a chisel. It came right out for me.
05-28-2019, 03:48 PM
Replies: 36
Views: 1,400
Posted By flukin nuts

I find my OX66 looses oil during the year. I fill...

I find my OX66 looses oil during the year. I fill it to the upper plug and when I drained it i got half out, Or i did before resealing. I never had water until a few years in one engine. The other...
05-21-2019, 06:11 PM
Replies: 40
Views: 2,980
Posted By flukin nuts

On one of mine the trim motor went last year. I...

On one of mine the trim motor went last year. I have bad corrosion around the thermostats in the block. Its almost threw the block now. I have owned them since 5 years old and I flush after every...
05-13-2019, 04:05 PM
Replies: 4
Views: 433
Posted By flukin nuts

They are really overbuilt and the boat will take...

They are really overbuilt and the boat will take more than you will. My brother has one and it will beat you up but he has no cracks anywhere.
05-09-2019, 03:46 PM
Replies: 38
Views: 1,036
Posted By flukin nuts

Your twisting up the wires pretty good. I slide...

Your twisting up the wires pretty good. I slide the rubber boot up and disconnect the harness and pull the plastic cover off first then twist the whole thing so you don't spin up the wires. Pennzoil...
05-03-2019, 03:07 PM
Replies: 6
Views: 390
Posted By flukin nuts

You sure its not the 27/28? I dont think the 26...

You sure its not the 27/28? I dont think the 26 came with twins.
04-30-2019, 03:13 PM
Replies: 5
Views: 164
Posted By flukin nuts

If there are any twisted areas I would straiten...

If there are any twisted areas I would straiten them out and don't worry about it. Its out of the water when on plane.
04-25-2019, 03:27 PM
Replies: 75
Views: 6,886
Posted By flukin nuts

Those are torque to yield bolts. You are...

Those are torque to yield bolts. You are basically stretching them and thats it. You tighten to a degree and stop. Supposed to be a one time use bolt.
04-23-2019, 02:35 PM
Replies: 75
Views: 6,886
Posted By flukin nuts

For light torques i use the beam type. For heavy...

For light torques i use the beam type. For heavy Ft pounds I go click. There are instances were you have to hold the torque and the beam is really the best for that. For spark plugs I use the bending...
04-21-2019, 06:39 AM
Replies: 25
Views: 1,196
Posted By flukin nuts

To start i think you might have to much prop....

To start i think you might have to much prop. That wont get you 1000 RPM but 21 might be too much pitch.
04-19-2019, 02:51 PM
Replies: 28
Views: 2,231
Posted By flukin nuts

I would foul o2 sensors and used to foul a plug...

I would foul o2 sensors and used to foul a plug once a year on Yamalube. It was a smokey mess. I switched to Penzoil 7 years ago and everything is much cleaner. O2 sensors, plugs always clean. I...
03-24-2019, 02:13 PM
Replies: 11
Views: 460
Posted By flukin nuts

Did you select the total scan transducer in the...

Did you select the total scan transducer in the setup menu? When I installed mine it would not side scan until i selected the correct transducer. Mine does not do well on plane in Chirp but very...
03-06-2019, 06:11 PM
Replies: 7
Views: 294
Posted By flukin nuts

My guess would be the water pump is leaking.

My guess would be the water pump is leaking.
03-02-2019, 06:15 AM
Replies: 52
Views: 3,992
Posted By flukin nuts

I have the Simrad RS 35 and one thing to remember...

I have the Simrad RS 35 and one thing to remember is its only a AIS receiver. You can see them but they cant see you. I had to shut my function off, every time I past a marina and was aimed toward I...
02-27-2019, 02:06 PM
Replies: 70
Views: 5,279
Posted By flukin nuts

I was taught a motor converts one form of energy...

I was taught a motor converts one form of energy to motion and a engine uses a fuel to make motion. Now I think its believed to be either but man I would get yelled at in school for using the wrong...
02-23-2019, 06:52 PM
Replies: 17
Views: 1,127
Posted By flukin nuts

My last boat had a old Sitex T-100. I mean from...

My last boat had a old Sitex T-100. I mean from the 80s with a manual tune it work fine. I could see land 16 miles out and other boats great, heavy rain but no birds. The radar I have now is a old...
02-18-2019, 11:09 AM
Replies: 13
Views: 432
Posted By flukin nuts

I used to foul a plug on one of my ox-66 every...

I used to foul a plug on one of my ox-66 every year sometimes a few times. I found the oil linkage out of adjustment and moved it almost back to the pin. This helped a lot. maybe fould one every...
02-18-2019, 06:20 AM
Replies: 24
Views: 1,607
Posted By flukin nuts

I had a 24 and with those large square scuppers...

I had a 24 and with those large square scuppers when the rubber leaked i would get a lot of water on the deck. Mine had light corrosion on the aluminum and I sanded and polished them up and made sure...
02-11-2019, 11:47 AM
Replies: 25
Views: 2,189
Posted By flukin nuts

[QUOTE=Brother Lou;12230615]I have a ‘99...

[QUOTE=Brother Lou;12230615]I have a ‘99 Aquasport 245 Explorer.


Did you move out of All seasons?
02-08-2019, 03:38 PM
Replies: 8
Views: 285
Posted By flukin nuts

How about the ones you see on high speed boats,...

How about the ones you see on high speed boats, long and narrow ones?
02-03-2019, 11:08 AM
Replies: 35
Views: 1,340
Posted By flukin nuts

Looking at your gauges I would say they are not...

Looking at your gauges I would say they are not accurate. The voltage is off on the two. If the voltage is different it can change the value of the fuel quantity.
02-03-2019, 11:03 AM
Replies: 7
Views: 498
Posted By flukin nuts

Make sure you pull out the tube (joint) that goes...

Make sure you pull out the tube (joint) that goes into the exhaust stream and clean it out while you have the housing off. Don't just unscrew the sensor. Take the housing off and clean it out and the...
01-28-2019, 06:30 PM
Replies: 6
Views: 384
Posted By flukin nuts

I would check the temp sensor or thermostat. When...

I would check the temp sensor or thermostat. When the engine is cold it idles up. If you have a bad stat it will idle up if it is stuck open or opening to early. had this happen a few times on mine....
01-28-2019, 10:13 AM
Replies: 61
Views: 5,361
Posted By flukin nuts

I have the same boat and drive over the side walk...

I have the same boat and drive over the side walk and never had a problem. When I used to park it at my parents house cause I could not were I am it did cause the blacktop to sink under the wheels. I...
01-27-2019, 06:36 AM
Replies: 100
Views: 22,439
Posted By flukin nuts

The left engine is higher than the right so maybe...

The left engine is higher than the right so maybe they raise.
Showing results 1 to 25 of 303
 


 
Forum Jump