Notices
 
Search: Posts Made By: norton79
Showing results 1 to 25 of 200
Search took 0.13 seconds.
05-01-2019, 06:37 PM
Replies: 5
Views: 231
Posted By norton79

Thank you for all your replies. If my friend...

Thank you for all your replies. If my friend connects both units with a yellow ethernet only will they sync or do they need nmea2000 aswell? Thanks
04-29-2019, 06:57 PM
Replies: 5
Views: 231
Posted By norton79

Evo3, go9, nmea2000 waypoint transfer

If a evo3 and go9 are connected via nmea2000 will waypoints made on the evo3 show on the go9? Waypoint sharing will be on for both. Go9 is used for maps and evo for sonar.
If so can you scroll back...
03-06-2019, 12:50 PM
Replies: 9
Views: 362
Posted By norton79

Is the ai transducer plugged into ch1 or ch2 on...

Is the ai transducer plugged into ch1 or ch2 on the nss? 1 would isolate that unit from the network and get it working before reconnecting
02-26-2019, 08:44 PM
Replies: 20
Views: 1,022
Posted By norton79

with reef master software you can take 2d sonar...

with reef master software you can take 2d sonar logs and make a 3d map of your water body and tilt and rotate it as you want. Check it out. There is a free 30day trial you can use, just load up some...
02-25-2019, 05:42 PM
Replies: 20
Views: 1,022
Posted By norton79

You can with your ti unit and use lowrances...

You can with your ti unit and use lowrances insight to create a map. A much better and also more expensive option is reefmaster software. This can make very good maps with the unit you have and if...
02-14-2019, 01:42 PM
Replies: 6
Views: 449
Posted By norton79

If you are connecting things like mfd's you will...

If you are connecting things like mfd's you will need a drop cable to connect them as well if they are not supplied with the equipment
01-09-2019, 05:38 PM
Replies: 5
Views: 361
Posted By norton79

Yes it does say not supported in both of them but...

Yes it does say not supported in both of them but if you go to the nss evo2 update page at least hear in australia you will find 18.3 update for the nss evo2 that does support the active imaging...
01-09-2019, 01:03 PM
Replies: 7
Views: 829
Posted By norton79

Also active imaging transducers support for evo2....

Also active imaging transducers support for evo2. I hope they release this for the hds gen3's aswell!
01-09-2019, 12:45 PM
Replies: 16
Views: 704
Posted By norton79

Hds gen3 has had it for a while aswell.

Hds gen3 has had it for a while aswell.
01-09-2019, 12:41 PM
Replies: 5
Views: 361
Posted By norton79

Nss evo2 update. Does this mean hds gen3 will get one aswell

Hi. A mate has just informed me there is a update for his nss evo2 so it can now support the active imaging transducer. Does this mean that the hds gen3 will get the same? I was under the impression...
12-10-2018, 01:42 PM
Replies: 26
Views: 1,135
Posted By norton79

If you have added a winch it should be on the...

If you have added a winch it should be on the start battery not the house battery and the motor should be running while using said winch. If this is still dragging down the voltage on your start...
11-15-2018, 01:12 PM
Replies: 106
Views: 34,054
Posted By norton79

Hi. I have a hds gen3 and have been thinking of...

Hi. I have a hds gen3 and have been thinking of upgrading from total scan to the new 3-1. I have read on a Facebook group I'm in hear in australia someone has connected there gen3 to the new tranny...
10-17-2018, 01:22 PM
Replies: 6
Views: 448
Posted By norton79

I have a similar solar setup but i use 2...

I have a similar solar setup but i use 2 regulators. I have 1 regulator per battery and both regulators connected to the solar panel. This setup has kept both my start and house batteries fully...
09-27-2018, 06:11 PM
Replies: 0
Views: 553
Posted By norton79

Lowrance live mapping

Looks good. Is anyone using it yet? Whats your thoughts on it?
09-05-2018, 02:33 PM
Replies: 3
Views: 279
Posted By norton79

On the new gen2 that is cannected to the radio...

On the new gen2 that is cannected to the radio via nema0183 you will need to make shore it is set to send out nmea0183 and it is set to the correct speed. I have a hds5x gen2 and a hds7 gen3 and have...
09-04-2018, 06:16 PM
Replies: 6
Views: 840
Posted By norton79

I have played around with the trial version and...

I have played around with the trial version and like it a lot. Haven't played with the bottom hardness yet. When funds become available I'll be purchasing the full version
08-30-2018, 01:02 AM
Replies: 5
Views: 494
Posted By norton79

I installed a ep60r and ep65r about 4 years ago...

I installed a ep60r and ep65r about 4 years ago and have never had a problem. Make shore you install the flow sensor so the fuel flows up through the sensor and not on it’s side as this can wear it...
08-17-2018, 02:37 AM
Replies: 15
Views: 582
Posted By norton79

You can also parallel solar chargers of a single...

You can also parallel solar chargers of a single panel. I run 2 5Amp charges off my 20w panel to charge and keep my start and house batteries while the boat sits in the yard ready for the next outing
07-25-2018, 01:38 PM
Replies: 410
Views: 103,937
Posted By norton79

Any updates? I have loved the write up and have...

Any updates? I have loved the write up and have been following near from the start. Would love to see some more pics and any more detail on what you love about what you have built and what you would...
07-02-2018, 02:08 PM
Replies: 4
Views: 559
Posted By norton79

You should have a main battery isolator that you...

You should have a main battery isolator that you turn off while storeing your boat that kills all power. This when switched off will solve the problem
07-01-2018, 06:06 PM
Replies: 3
Views: 362
Posted By norton79

There is a plugin to opencpn for the simrad br24...

There is a plugin to opencpn for the simrad br24 radar. I think thats the right model. I haven't used it so cannot go into details. If you do a google search for opencpn forum you will find all the...
06-05-2018, 02:22 AM
Replies: 44
Views: 17,372
Posted By norton79

Hi mate. Can you give us a pin/ wire colour for...

Hi mate. Can you give us a pin/ wire colour for the rj45. Thanks
04-26-2018, 12:07 AM
Replies: 2,214
Views: 547,703
Posted By norton79

It is a canbus based on device net. You will need...

It is a canbus based on device net. You will need to find out the pg’s used buy you outboard and how to convert them to something you can use
04-06-2018, 10:35 PM
Replies: 2
Views: 426
Posted By norton79

With the hds5x and lss1 box with lss2 transducer...

With the hds5x and lss1 box with lss2 transducer and 50/200hdi i would use the side scan to look for bait while trolling. My thinking is the totalscan is a lss2 with 83/200 built in i should be able...
04-06-2018, 02:19 AM
Replies: 2
Views: 426
Posted By norton79

Hds gen3 hdi, totalscan and lss-1

I have a hds gen3 with totalscan that i run in the salt water lakes near my home hear in Australia. I also have a 50/200hdi that i use outside in deeper water. Can i connect my totalscan to my old...
Showing results 1 to 25 of 200
 


 
Forum Jump