Notices
 
Search: Posts Made By: Chris2592
Showing results 1 to 25 of 100
Search took 0.06 seconds.
06-30-2020, 09:44 PM
Replies: 0
Views: 179
Posted By Chris2592

Ram 1500 P0440 CEL Code

Just a heads up if you get a P0440 Code on a newer ram 1500 it can be anything from the emissions system, but the most likely candidate is the fuel leak detection pump, itís 30 dollars. Hopefully...
06-06-2020, 01:50 PM
Replies: 10
Views: 268
Posted By Chris2592

will make sure to keep all surfaces free of...

will make sure to keep all surfaces free of moisture thank you.
06-06-2020, 01:48 PM
Replies: 10
Views: 268
Posted By Chris2592

Is that recommended with a manual start motor as...

Is that recommended with a manual start motor as well? thatís what I run . There is never a battery in the boat or any electronics.
06-06-2020, 11:17 AM
Replies: 10
Views: 268
Posted By Chris2592

I added the bunk slicks for that exact reason...

I added the bunk slicks for that exact reason keep it off the carpet, my last metal boat died from pinholes so Iím trying to figure out other ways to make this one more corrosion proof
06-06-2020, 11:15 AM
Replies: 10
Views: 268
Posted By Chris2592

That makes sense to me thanks!

That makes sense to me thanks!
06-06-2020, 07:59 AM
Replies: 10
Views: 268
Posted By Chris2592

Sacrificial Anodes on Jon Boat

Hey all, curious as to whether it makes sense to mount an anode somewhere on a 16ft aluminum boat, it sits on a trailer but is used solely in saltwater, would like to do all I can to prevent...
05-22-2020, 08:00 PM
Replies: 11
Views: 374
Posted By Chris2592

Check your fuel line, sometimes the plastic...

Check your fuel line, sometimes the plastic lining inside the hose starts coming apart from the rubber and starts causing trouble, had the same issue you described, turned out that was the issue, the...
05-17-2020, 06:59 PM
Replies: 3
Views: 505
Posted By Chris2592

You are correct, hit it with 120 grit and it...

You are correct, hit it with 120 grit and it cleaned right up so all is well thank you for pointing that out.
05-17-2020, 01:59 PM
Replies: 3
Views: 505
Posted By Chris2592

2019 Trailer rust

So I wanted to install a keel roller on the rear of my trailer, when I took the screws out holding the keel pad in the trailer I noticed itís rusting a good bit, trailer is washed thoroughly every...
05-15-2020, 05:34 AM
Replies: 30
Views: 1,003
Posted By Chris2592

Iím in DE as well, where are you planning on...

Iím in DE as well, where are you planning on going? the inland bays can be quite treacherous in certain spots as far as depth goes
03-22-2020, 08:58 AM
Replies: 24
Views: 1,356
Posted By Chris2592

Thanks Maxxi thrilled with how it turned out for...

Thanks Maxxi thrilled with how it turned out for sure.
Forum: Dockside Chat
03-22-2020, 07:07 AM
Replies: 0
Views: 208
Posted By Chris2592

First Aid and the Coast Guard

So I received a letter from the NMC regarding my captains course, seems my only screw up was that I didnít know your first aid cert needed to be in the last 12 months, I figured it was kosher as long...
03-21-2020, 06:27 AM
Replies: 24
Views: 1,356
Posted By Chris2592

Thanks Duke!

Thanks Duke!
03-20-2020, 08:57 PM
Replies: 24
Views: 1,356
Posted By Chris2592

Just figured in case anyone has the same problem...

Just figured in case anyone has the same problem I would update my post, had a local guy weld up a custom transom elevator, everything is perfect now, problem solved and thanks everyone for the help...
03-14-2020, 03:05 PM
Replies: 24
Views: 1,356
Posted By Chris2592

Will get on that thanks HTJ

Will get on that thanks HTJ
03-14-2020, 07:25 AM
Replies: 24
Views: 1,356
Posted By Chris2592

HTJ disregard, I looked at your post again from...

HTJ disregard, I looked at your post again from before, did you use a Jigsaw to cut the channels for the adjustment bolts?
03-14-2020, 07:18 AM
Replies: 24
Views: 1,356
Posted By Chris2592

thanks HTJ, do you think you could give me a...

thanks HTJ, do you think you could give me a quick run down on how you made that, it looks slick!
03-14-2020, 06:29 AM
Replies: 24
Views: 1,356
Posted By Chris2592

Man thatís bad news. I still canít believe I...

Man thatís bad news. I still canít believe I screwed it up even i just assumed since it says itís for a 20inch transom- The L by itself underneath model# that itís still wrong , I researched it a lot...
03-13-2020, 10:09 PM
Replies: 24
Views: 1,356
Posted By Chris2592

Thanks for all the replies so far I have some...

Thanks for all the replies so far I have some ideas to Jack it up higher that Iím thinking about, I assure everyone I would not make the mistake of getting the wrong length shaft, this is what is so...
03-13-2020, 06:25 PM
Replies: 24
Views: 1,356
Posted By Chris2592

Do I need a jack plate?

Hey all, I just repowered my duck boat with a Yamaha 15hp, my transom is 20Ē so I made sure the it was a long shaft outboard, noticed when it was mounted that the ventilation plate sits about 4Ē...
01-17-2020, 04:35 PM
Replies: 8
Views: 874
Posted By Chris2592

Passed through Masseyís heading south they are...

Passed through Masseyís heading south they are dredging the north side of middle island with the pipe going across Masseyís to Robinson island, was able to motor over the pipe as it was sunk to the...
12-01-2019, 09:35 AM
Replies: 7
Views: 853
Posted By Chris2592

If you can just pop the cowling off and remove...

If you can just pop the cowling off and remove the whole hose it runs from intake/thermostat housing to tell tale, much easier to clean the hose out that way.
11-20-2019, 04:29 PM
Replies: 19
Views: 1,410
Posted By Chris2592

Nice man thank you!

Nice man thank you!
11-20-2019, 03:47 PM
Replies: 19
Views: 1,410
Posted By Chris2592

What mount are you using on your tablet? It looks...

What mount are you using on your tablet? It looks pretty slick
11-15-2019, 11:09 PM
Replies: 65
Views: 11,032
Posted By Chris2592

Itís funny I used to drool over Parkerís, having...

Itís funny I used to drool over Parkerís, having used one for the past two years I will never look at a pilot house boat the same, unless itís displacement like a DE style hull people keep talking...
Showing results 1 to 25 of 100
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.