Notices
Search: Posts Made By: hamilton
Showing results 1 to 10 of 10
Search took 0.03 seconds.
12-05-2017, 05:43 PM
Replies: 15
Views: 2,335
Posted By hamilton

I'll have to take a few photos. I thought I had...

I'll have to take a few photos. I thought I had some but could not locate on the PC.
12-05-2017, 05:40 PM
Replies: 15
Views: 2,335
Posted By hamilton

Fredericksburg. I'll pull leaning post/live well...

Fredericksburg. I'll pull leaning post/live well and cut section of floor to see what all is going on. This cut would be needed in any case to get access to gas tank.

I'll hole saw forward of...
12-05-2017, 01:05 PM
Replies: 15
Views: 2,335
Posted By hamilton

Thinking about trashing the boat. I found...

Thinking about trashing the boat. I found stringers are gone and large section of floor needs replacement.
12-03-2017, 07:20 PM
Replies: 15
Views: 2,335
Posted By hamilton

Finally had time and health to get back to the...

Finally had time and health to get back to the project. All wood has been removed from transom. I have settled on the CarbonCore approach due in part due to pickup only 45 miles away instead of...
01-14-2017, 03:27 PM
Replies: 15
Views: 2,335
Posted By hamilton

I have decided to go with Carbon-Core. I can get...

I have decided to go with Carbon-Core. I can get it from place 1 hour away and save on shipping. It also appears to easier to mix than SeaCast.


I will also go with glassing the seam in the skin....
01-13-2017, 09:26 PM
Replies: 15
Views: 2,335
Posted By hamilton

I am beginning to think the contrary . Since...

I am beginning to think the contrary . Since the NidaCore will be a basic fiberglass base it should flex about the same as the glass skins over wood. So what is lost in the small butt joint fix?
01-11-2017, 04:00 PM
Replies: 15
Views: 2,335
Posted By hamilton

Thanks for the link. I also found this similar...

Thanks for the link. I also found this similar project http://www.thehulltruth.com/boating-outdoor-photos/287659-replacing-old-transom-pour.html


Both used a 100% pour. Accountability taper...
01-11-2017, 09:31 AM
Replies: 902
Views: 299,145
Posted By hamilton

CoastalFiberglass I am doing a transom...

CoastalFiberglass

I am doing a transom rebuild on a Crist Craft 31ft CC and I removed the outer skin similar to your Fountain.
However I left a 4 inch of the skin around the perimeter.

At the...
01-10-2017, 11:43 AM
Replies: 15
Views: 2,335
Posted By hamilton

Transom Rebuild

I will be rebuilding the transom on a 32 ft CC this spring. I have removed a large section of the outer skin and removed 90 percent of the old plywood.


I am thinking about using Coosa to...
01-10-2017, 11:11 AM
Replies: 0
Views: 346
Posted By hamilton

Transom Rebuild

I will be rebuilding the transom on a 32 ft CC this spring. I have removed a large section of the outer skin and removed 90 percent of the old plywood.


I am thinking about using Coosa to replace...
Showing results 1 to 10 of 10


 
Forum Jump