Notices
 
Search: Posts Made By: wetneck
Showing results 1 to 25 of 500
Search took 0.19 seconds.
04-15-2021, 09:40 AM
Replies: 8
Views: 1,027
Posted By wetneck

So I have from inside, 4 layers of 1708, tabbed...

So I have from inside, 4 layers of 1708, tabbed approx 8" in, 1" coosa , 3/4" coosa, 1 layer of 1708 .
I have about 3/8" left to flush to outside.
my question is should I add approx 6-7 layers of...
03-26-2021, 07:13 AM
Replies: 8
Views: 1,027
Posted By wetneck

Yea rear floor out now, all ground out and ready...

Yea rear floor out now, all ground out and ready to start fitting coosa. What I would LIKE to do is install approx 12" hi across bottom, to be able to tab to floor at outer, center is fully...
03-21-2021, 08:31 AM
Replies: 8
Views: 1,027
Posted By wetneck

As I said above I watched a few YouTube's whereas...

As I said above I watched a few YouTube's whereas they redid from out, so this is the point I'm at.
the inside skins werent even 1708, flimsy crap, it's surprising how poorly these were...
03-21-2021, 07:52 AM
Replies: 8
Views: 1,027
Posted By wetneck

89' 25' H/S transom replacement

After many years of beating its time to tighten up her rear end, prefer to complete transom then next down time do stringers.
Have seen and read a few rebuilds on here but have a dozen questions but...
11-06-2020, 04:37 PM
Replies: 7
Views: 352
Posted By wetneck

While running pump dry, for giggles test fuel...

While running pump dry, for giggles test fuel pressure
10-14-2020, 07:21 AM
Replies: 12
Views: 2,634
Posted By wetneck

Good looking hull, really resembles Olympia also

Good looking hull, really resembles Olympia also
08-18-2020, 04:05 PM
Replies: 0
Views: 198
Posted By wetneck

Double axel 24-26' rusty tongue

My tongue is rusted at opposite end of coupler and needs replacing.
im sure i can locate the galv equivalent but has anyone successfully used structural aluminum as it is much more user friendly ,...
08-10-2020, 11:00 AM
Replies: 19
Views: 450
Posted By wetneck

Ensure you dont have water flowing out of upper...

Ensure you dont have water flowing out of upper exhaust ports at low rpms.
i know you replaced prv but a low rpm overheat still points to low system flow at low rpms.
08-02-2020, 07:25 AM
Replies: 9
Views: 351
Posted By wetneck

.

.
07-20-2020, 07:59 AM
Replies: 38
Views: 1,559
Posted By wetneck

Check if tank has checkvalve/screen Replace vst...

Check if tank has checkvalve/screen
Replace vst filter
clean basket filters and pres reg filter
ohm test plug caps
delete check valve
recheck lift pumps
07-08-2020, 06:00 AM
Replies: 13
Views: 600
Posted By wetneck

Shows both springs out, not sure why as theyre...

Shows both springs out, not sure why as theyre then exposed to full salt, at least in a large percentage of usages.
...
07-02-2020, 05:32 PM
Replies: 9
Views: 317
Posted By wetneck

Have you cleaned carbs ???

Have you cleaned carbs ???
06-30-2020, 04:47 PM
Replies: 15
Views: 488
Posted By wetneck

Replace vst filter test 02

Replace vst filter
test 02
06-17-2020, 05:39 PM
Replies: 6
Views: 282
Posted By wetneck

3-6, change quickly "Servicing yamahas super...

3-6, change quickly
"Servicing yamahas super sniffer"
06-03-2020, 09:01 AM
Replies: 6
Views: 448
Posted By wetneck

Looks to me like its dripping from above if...

Looks to me like its dripping from above
if not, they easily pull/twist out and simply push back in, careful ordering as there are a couple different sizes and diagrams arent the best
06-01-2020, 10:13 AM
Replies: 4
Views: 519
Posted By wetneck

You replaced the seperator, what was in it ?

You replaced the seperator, what was in it ?
05-22-2020, 03:10 PM
Replies: 22
Views: 1,019
Posted By wetneck

Check voltage at starter relay check for...

Check voltage at starter relay
check for corrosion at 10 pin harness ends
one starts and one doesnt ?
port, starboard...
05-20-2020, 06:25 AM
Replies: 16
Views: 825
Posted By wetneck

Looks like 96-03 has the same base gasket, so...

Looks like 96-03 has the same base gasket, so powerhead could be any of those yrs
or someone could have swapped full intake, etc.
05-16-2020, 08:40 PM
Replies: 6
Views: 774
Posted By wetneck

Clear laminate , 3m clear tint etc

Clear laminate , 3m clear tint etc
05-15-2020, 10:10 AM
Replies: 9
Views: 911
Posted By wetneck

You see the voltage change but it needs to run...

You see the voltage change but it needs to run the range from lo to high, quickly
05-12-2020, 02:22 PM
Replies: 29
Views: 1,869
Posted By wetneck

So did your mechanic say this is normal and he...

So did your mechanic say this is normal and he gave it back to you ?
it seems you have excess fuel dumping out of exhaust, lp pumps, weak /non firing cylinder, open injector etc.
so you put more...
05-11-2020, 07:27 PM
Replies: 10
Views: 429
Posted By wetneck

Loose neutral switch in 704

Loose neutral switch in 704
05-11-2020, 02:58 PM
Replies: 29
Views: 1,869
Posted By wetneck

Do you still have a checkvalve ? ohm test plug...

Do you still have a checkvalve ?
ohm test plug caps ?
05-11-2020, 05:35 AM
Replies: 6
Views: 268
Posted By wetneck

If its not charging you need to check output...

If its not charging you need to check output voltage from regulator

if you need that much power to load, you should really just back trailer a bit deeper.
05-10-2020, 05:23 PM
Replies: 6
Views: 268
Posted By wetneck

your lower unit is buried deep on ramp when...

your lower unit is buried deep on ramp when loading.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.