Notices
Search: Posts Made By: Bounty
Showing results 1 to 17 of 17
Search took 0.03 seconds.
Forum: West Coast
07-21-2020, 12:21 PM
Replies: 7
Views: 734
Posted By Bounty

The lifeguard boat will intervene if you even get...

The lifeguard boat will intervene if you even get too close to the outside waves around here.
not only illegal, but it would be foolish as well. Way to much surf. If not when you beach it, there...
Forum: West Coast
06-02-2020, 08:40 PM
Replies: 5
Views: 1,954
Posted By Bounty

I didn’t have any propane bottles. My stove is...

I didn’t have any propane bottles. My stove is electric. No gas can either. I’ve got a Torquedo electric outboard.
the box is easy to take off if the boats on a trailer. I had to have my bottom...
Forum: West Coast
05-12-2020, 11:42 PM
Replies: 5
Views: 1,954
Posted By Bounty

BTW, the tank comes off with 4 screws and a hose...

BTW, the tank comes off with 4 screws and a hose connection. To get access to the gen set under the seat.
it just slides back out of the way.
Forum: West Coast
05-12-2020, 11:39 PM
Replies: 5
Views: 1,954
Posted By Bounty

I’ve got a 2018 Cutwater 30-CB. 435hp. I fish...

I’ve got a 2018 Cutwater 30-CB. 435hp.
I fish and cruise in So Cal. While 20 knots is very doable, 25 is well beyond its capability. I top out about 22+ knots at WOT.
I’ve got a 38 gal bait tank on...
04-16-2020, 12:04 PM
Replies: 3
Views: 692
Posted By Bounty

Sorry it took a few days to get back to you. ...

Sorry it took a few days to get back to you.
The trailer is in storage. I’ll try and get over and take a couple of pics today.
Steve
04-09-2020, 05:50 PM
Replies: 3
Views: 692
Posted By Bounty

I’ve got a 2017 14K aluminum triple axle trailer...

I’ve got a 2017 14K aluminum triple axle trailer available in Southern California. $6,500.
I had a 30’ Cutwater inboard on it. It’s only had one run on it. From Idaho to So Cal.
just hanging out in...
09-15-2019, 02:03 PM
Replies: 1
Views: 336
Posted By Bounty

I've got a near new 14K triple axle EZLoader...

I've got a near new 14K triple axle EZLoader aluminium trailer I'm looking to sell.
It was only used to bring my 30' cutwater down from Idaho this spring. It's never been in salt water.
$7,500 OBO....
03-03-2019, 11:44 AM
Replies: 4
Views: 886
Posted By Bounty

I'm going to have a almost new 2018 EZ Loader...

I'm going to have a almost new 2018 EZ Loader 14,000# triple axle Aluminum trailer available in a week or two.
Huntington Beach. CA.
My 30' Cutwater is on it being towed down from Idaho on Tuesday,...
02-14-2017, 11:08 AM
Replies: 13
Views: 3,545
Posted By Bounty

Well, my Bravo III X Deisel went south again. ...

Well, my Bravo III X Deisel went south again.
I've ordered the Yanmar ZT-370.
My Yanmar dealer is only a few miles away so hopefully any parts will be available.
Expensive? No doubt.
The Yanmar...
12-16-2014, 12:30 PM
Replies: 1
Views: 573
Posted By Bounty

I would doubt it. The Yanmar 6LP is a...

I would doubt it.
The Yanmar 6LP is a mechanical engine with no computer of it's own.
11-17-2014, 10:53 AM
Replies: 13
Views: 3,545
Posted By Bounty

I think you go this route after replacing 2 or 3...

I think you go this route after replacing 2 or 3 Bravo IIIs because of gear failures.
The Mercruiser Bravo III units don't last in my Yanmar 6LP. And this is a known weak point on heavy boats. It...
11-05-2014, 04:18 PM
Replies: 125
Views: 29,004
Posted By Bounty

Just an FYI for those wanting to get one of these...

Just an FYI for those wanting to get one of these this year.
I ordered a loaded 2500HD LTZ D-Max on Oct. 1st and just got notified they are starting the build on Nov. 24th.
I should take delivery...
12-05-2013, 04:32 PM
Replies: 87
Views: 19,045
Posted By Bounty

Networking?

Gil, will the GCV 10 be able to display on the older MFDs?
NEMA 2000 to a 4208?
Thanks, Steve
07-23-2013, 02:04 PM
Replies: 19
Views: 5,142
Posted By Bounty

Stern Anchor?

I live in So Cal and fish / boat at Catalina all the time.
While a stern anchor is not a good idea most places, it is a required piece in a tight, protected anchorage. Where swinging with the tide /...
09-27-2012, 12:22 PM
Replies: 56
Views: 10,071
Posted By Bounty

Pelican Cooler

I'm interested too.
08-06-2012, 12:50 PM
Replies: 6
Views: 1,245
Posted By Bounty

Temp gauge calibration?

I put in a Cruzpro Sea Temperature gauge a while back and calibrated it with a digital oven thermometer. Now I've got a new Garmin 4208 w/ temp from the new transducer and they're around 2° off. I...
05-02-2012, 05:10 PM
Replies: 6
Views: 1,149
Posted By Bounty

Cruz-Pro

I installed the Cruz Pro WPT-65 Temp Gauge last year and it's done the job.
My temp sensor went out on my transducer as well, so a cheaper way to go was the separate sensor.
The Cruz Pro reads in...
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.