Notices
 
Search: Posts Made By: Kid Stuff
Showing results 1 to 25 of 500
Search took 0.54 seconds.
06-09-2012, 04:00 PM
Replies: 1
Views: 480
Posted By Kid Stuff

Sounds like the high speed jet in one of the...

Sounds like the high speed jet in one of the carbs is clogged. get some Merc Power Tune and remove the drain from the carb bowl and spray the power tune in the drain openingtill it comes out the...
06-07-2012, 04:07 PM
Replies: 25
Views: 11,750
Posted By Kid Stuff

I have the same set-up (2002) since new. The boat...

I have the same set-up (2002) since new. The boat is a great skiff which I fish very hard in the Sandy Hook, NJ area. The motor is bullet proof and any mech can work on it. It isnt the fastest but...
09-29-2010, 10:08 PM
Replies: 32
Views: 2,220
Posted By Kid Stuff

The best!!!!!!!!!!!

The best!!!!!!!!!!!
09-12-2010, 07:46 PM
Replies: 7
Views: 951
Posted By Kid Stuff

1. Drop the lower unit. 2. move shift lever into...

1. Drop the lower unit. 2. move shift lever into forward. 3.Shift gear housing into forward by rotating the shift shaft coupler on the lower unit. In forward gear the gear housing will ratchet when...
09-12-2010, 07:23 PM
Replies: 15
Views: 12,492
Posted By Kid Stuff

Load up a few pie trays with old fashion moth...

Load up a few pie trays with old fashion moth balls....rodents can't stand the smell and will stay out.
08-22-2010, 03:45 PM
Replies: 3
Views: 596
Posted By Kid Stuff

until the fuel in the float chambers evaporates...

until the fuel in the float chambers evaporates some
08-16-2010, 07:28 PM
Replies: 15
Views: 3,757
Posted By Kid Stuff

Like I said, that water is on the exhaust side...

Like I said, that water is on the exhaust side and is what eventually goes through the pop hub. Just forget about it and dont waste money on a spacer. It isnt precission machined. If it bothers you ,...
08-16-2010, 02:50 PM
Replies: 11
Views: 7,524
Posted By Kid Stuff

ditto;)

ditto;)
08-16-2010, 09:38 AM
Replies: 3
Views: 6,204
Posted By Kid Stuff

http://www.mercurypartsexpress.com/us/parts-search...

http://www.mercurypartsexpress.com/us/parts-search.html#mr1374ar12612

You most lkely have a bad connection. Clean them and try some dialectric grease. Not likely the motor. Check the relays and...
08-16-2010, 09:13 AM
Replies: 15
Views: 3,757
Posted By Kid Stuff

http://www.mercurypartsexpress.com/us/parts-search...

http://www.mercurypartsexpress.com/us/parts-search.html#mr1374ar12607 If you zoom in on the diagram you will see the spot on the mating surface that calls for a bead of silicone sealant. I agree that...
08-16-2010, 08:59 AM
Replies: 15
Views: 3,757
Posted By Kid Stuff

It is actually leaking from the exhaust side of...

It is actually leaking from the exhaust side of the water circulation and is not an issue. If the "pee stream" is strong and no overheat issues then it's ok and can wait. There is a small bead of...
05-16-2008, 04:56 PM
Replies: 20
Views: 3,466
Posted By Kid Stuff

Re: how to remove a broken bolt?

They break too. Heat and penetrating oil is a must. Start small and work up with the bits. DO NOT FORCE IT!!!!!!
05-16-2008, 04:50 PM
Replies: 4
Views: 773
Posted By Kid Stuff

Re: Merc 15HP 4S carb issue

Even with an easy out you are going to need heat cause it is probably varnished in. Use a high powered soldering iron or a heat gun.
05-14-2008, 07:05 AM
Replies: 26
Views: 7,102
Posted By Kid Stuff

Re: Durango Towing

I have a 1999 w/5.2 engine at 170000 miles. I tow 4k with no problem. Original tranny (only changed fluid once). The car is a tank and I average 12mpg city/hwy combined. I must be one of the lucky...
05-07-2008, 07:44 PM
Replies: 4
Views: 695
Posted By Kid Stuff

Re: Surveyor in Point Pleasent NJ Area?

Call Dunk. http://www.thehulltruth.com/forums/thread-view.asp?tid=196252&posts=6&mid=2047878
05-07-2008, 07:35 PM
Replies: 7
Views: 1,964
Posted By Kid Stuff

Re: Merc 90ELPTOSW fuel problem and Prop question!

There is a drain plug on the side of each carb. The top two can be opened with a screw driver. The bottom needs a 1/4 inch drive extension and universal. Open the carb drains. Behind them is the high...
05-03-2008, 03:33 PM
Replies: 22
Views: 8,777
Posted By Kid Stuff

Re: 88 bayliner bilge drain question

WRONG!!!!!!! It was a maximum of $188.72. :grin:
04-28-2008, 02:17 PM
Replies: 23
Views: 4,481
Posted By Kid Stuff

Re: Removing water lines and stains from hull

Go to Home Depot and get zep deck and fence cleaner and mix 50% water in a spray bottle. Works great and is cheap. It is oxalic acid same as on/off but only $8 /gal.
04-06-2008, 05:02 PM
Replies: 13
Views: 3,179
Posted By Kid Stuff

Re: Broken pinion gear

Shimming should not be a big deal for an experienced merch. When I had a pinion gear on my merc replaced, I got a one year warranty. 90 days is a bit light. Why did it go? Did you hit something? They...
04-04-2008, 09:09 AM
Replies: 11
Views: 9,518
Posted By Kid Stuff

Re: Anyone ever bend 7/8" Stainless Tube yourself

Tape the ends and fill with sand. Add heat to bend area. The sand will prevent the pipe from kinking.
03-04-2008, 12:20 PM
Replies: 15
Views: 1,191
Posted By Kid Stuff

RE: Busted powerhead...need advice on options

So get a uhaul van drive, down and get it for $8300 and hang it yourself. Done! :thumbsup:
http://www.edsmarinesuperstore.com/mercury.htm
01-27-2008, 07:06 AM
Replies: 47
Views: 6,254
Posted By Kid Stuff

Re: BOSTON WHALER OR MAYCRAFT?

Whalers suck!!! Ask anyone who doesn't own one or has never rode in one. They are overpriced, they absorb water (right they don't sink), they ride like sh%t, etc., etc,. People like me who have been...
Forum: Northeast
01-06-2008, 10:14 AM
Replies: 12
Views: 2,811
Posted By Kid Stuff

Re: Texas Tower History

There were a few. http://www.radomes.org/museum/documents/TexasTower.html
12-10-2007, 07:15 PM
Replies: 31
Views: 4,052
Posted By Kid Stuff

Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.