Notices
 
Search: Posts Made By: Agreene
Showing results 1 to 25 of 301
Search took 0.25 seconds.
06-03-2016, 02:42 PM
Replies: 8
Views: 1,359
Posted By Agreene

still for sale?

still for sale?
05-19-2016, 10:38 AM
Replies: 9
Views: 1,378
Posted By Agreene

still for sale? Thanks Agreene

still for sale?


Thanks
Agreene
01-29-2016, 05:06 PM
Replies: 54
Views: 10,142
Posted By Agreene

All PM's have been replied too and emails w/ info...

All PM's have been replied too and emails w/ info have been sent
01-28-2016, 09:42 AM
Replies: 54
Views: 10,142
Posted By Agreene

No email received

No email received
01-27-2016, 10:09 AM
Replies: 54
Views: 10,142
Posted By Agreene

23 Gulf. I have a 98' 23 Reg. Has a 2011 Yamaha...

23 Gulf. I have a 98' 23 Reg. Has a 2011 Yamaha F300 with Command Link and Fly-by-wire, warranty till Aug 2016. Hasn't missed a beat and don't expect it to @390 hours, dealer maintained. Garmin 4210...
02-11-2015, 08:08 PM
Replies: 23
Views: 5,506
Posted By Agreene

23' Regulator Classic. 99' Hull with 2011 Yamaha...

23' Regulator Classic. 99' Hull with 2011 Yamaha F300 Offshore outboard with 300 hours and warranty through 8/2016. Garmin 4210 with radar and Furuno 600 FF with Airmar B60 through hull transducer....
05-31-2012, 04:21 AM
Replies: 10
Views: 12,324
Posted By Agreene

thoughts on spacer placement?

thoughts on spacer placement?
05-30-2012, 04:13 AM
Replies: 10
Views: 12,324
Posted By Agreene

What is the minimum bend radius for the hydraulic...

What is the minimum bend radius for the hydraulic hoses? I have bulkhead fittings in the splashwell, with two hoses connected from the bulkhead fittings to the cylinder. One is of adequate length,...
05-29-2012, 04:27 PM
Replies: 10
Views: 12,324
Posted By Agreene

I loosened this nut, it seemed very tight. I...

I loosened this nut, it seemed very tight. I loosened it too much initially as there was play in the cylinder when the wheel was turned back and forth. I left the adjusting nut such that it was just...
05-29-2012, 03:24 AM
Replies: 10
Views: 12,324
Posted By Agreene

Thanks for the comments. However, I've had a...

Thanks for the comments. However, I've had a seastar setup on two different boats and with a 1.7 helm I could turn with a single finger. My friends boat has twin 200s and at idle we can turn his...
05-28-2012, 03:31 PM
Replies: 10
Views: 12,324
Posted By Agreene

Stiff Seastar steering

The helm is a 1.7 tilted helm, seastar hydraulic. Now the steering isn't hugely stiff and it's pretty smooth, but definitely not what a 1.7 helm setup should be. At neutral, I "should" be able to...
04-20-2012, 04:15 PM
Replies: 18
Views: 1,597
Posted By Agreene

That was awesome. That's all I have to say.

That was awesome. That's all I have to say.
04-01-2012, 05:21 AM
Replies: 4
Views: 862
Posted By Agreene

Someone must need this. Can't hold on to it much...

Someone must need this. Can't hold on to it much longer.

I've posted this L/U several times with almost zero response. What's the major drawback?
Price?
SEI? At least as of 2009, I was under...
03-31-2012, 07:01 AM
Replies: 4
Views: 862
Posted By Agreene

Yamaha Lower unit Ox66 250hp

This is an SEI replacement lower unit for 1998 OX66 250 with a 30" shaft, however I believe it fits any 76 degree V6 yamaha block. It was purchased brand new in July 2009 and taken out of service in...
01-22-2012, 10:19 AM
Replies: 2
Views: 584
Posted By Agreene

Sorry for the delayed response. It is a 30"...

Sorry for the delayed response. It is a 30" shaft. I blew the powerhead on my ox66, since the L/U was new I pulled it off before bringing the boat into the dealer for the repower. New water pump in...
01-15-2012, 07:54 AM
Replies: 2
Views: 584
Posted By Agreene

Yamaha SEI V6 Lower unit

Fits 76 degree V6 blocks. This came off a 98' ox66 250hp. The unit was purchased and installed brand new July 2009. Asking $400.
11-19-2011, 02:53 PM
Replies: 3
Views: 1,107
Posted By Agreene

trailer tire wear

Dual axle leaf-spring trailer

The inner portion (facing the boat) on 2 of the 4 tires is wearing much much more than other parts of the tire. On one of the tires it is nearly bald. The 4 tires...
11-13-2011, 10:13 AM
Replies: 0
Views: 471
Posted By Agreene

Yamaha Lower unit $450, new in 2009

This is an SEI unit purchased in July 2009. Probably has ~100 hours on it. Fits all 74 degree V6 blocks. I had it on an 98' 250 ox66. Bring offers.

What you see on the nose of the L/U is the scum...
11-02-2011, 06:09 PM
Replies: 54
Views: 37,513
Posted By Agreene

what imron color is that?

what imron color is that?
10-11-2011, 06:39 PM
Replies: 5
Views: 1,253
Posted By Agreene

It was the tilt mechanism. Works fine again.

It was the tilt mechanism. Works fine again.
10-07-2011, 05:22 PM
Replies: 5
Views: 1,253
Posted By Agreene

Thanks. Let me try some of these suggestions...

Thanks. Let me try some of these suggestions tomorrow.
10-06-2011, 07:20 PM
Replies: 5
Views: 1,253
Posted By Agreene

Seastar steering rough spots

This is 1.7 tilt helm and the problem just started after not using the boat for 10 days. Over the course of the 4.7 turns lock-to-lock there are ~ 4-5 rough spots. What I mean by rough is that 90% of...
09-15-2011, 02:47 AM
Replies: 6
Views: 1,002
Posted By Agreene

Repower with an offshore series yamaha 4 stroke,...

Repower with an offshore series yamaha 4 stroke, they are much lighter than their 4 stroke predecessors or stay 2 stroke. I went from a 250 yamaha 2 stroke to a F300 4stroke and the weight difference...
09-05-2011, 06:23 PM
Replies: 16
Views: 2,850
Posted By Agreene

No hour meter, but based on usuage...~1500 hrs

No hour meter, but based on usuage...~1500 hrs
09-05-2011, 12:04 PM
Replies: 2
Views: 405
Posted By Agreene

price drop $75

price drop $75
Showing results 1 to 25 of 301
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.