Notices
 
Search: Posts Made By: Bayfly
Showing results 1 to 25 of 500
Search took 0.36 seconds.
Yesterday, 06:44 PM
Replies: 2
Views: 169
Posted By Bayfly

As an Xi5 owner I'm interested in where you are...

As an Xi5 owner I'm interested in where you are going, but can only add, aluminum painted or unpainted is going to corrode, sooner or later. I even have a galvanized aluminum bulkhead which corrodes....
Yesterday, 10:02 AM
Replies: 5
Views: 245
Posted By Bayfly

I suggest you address this matter with you state...

I suggest you address this matter with you state marine authorities. You don't have to identify yourself in case you want to take a few short cuts, but at least you know the requirements from their...
Yesterday, 09:58 AM
Replies: 37
Views: 1,035
Posted By Bayfly

Don't forget their nest, and pepper it with your...

Don't forget their nest, and pepper it with your 410. WD40 should take care of the duck tape residue. Good luck!:banghead:
01-13-2021, 10:46 AM
Replies: 15
Views: 610
Posted By Bayfly

Terrible ideal, and I suggest you find someone...

Terrible ideal, and I suggest you find someone with experience in T-tops and with some engineering background.:thumbsup:
01-11-2021, 03:31 PM
Replies: 57
Views: 2,809
Posted By Bayfly

I suggest you watch for a hull of your choice...

I suggest you watch for a hull of your choice which needs a re-power, then find a replacement engine or a new one. This is depending on your being a person of willing mechanical ability. If you can...
01-11-2021, 08:52 AM
Replies: 20
Views: 918
Posted By Bayfly

I once ask a very reputable fiberglass repair...

I once ask a very reputable fiberglass repair company what it would cost to re-gelcoat the bottom of a 23 shallow water hull and the owner said they do not encourage the service, because the cost is...
01-10-2021, 05:04 PM
Replies: 62
Views: 5,078
Posted By Bayfly

This is my favorite nail remover!:thumbsup:

This is my favorite nail remover!:thumbsup:
01-10-2021, 02:58 PM
Replies: 16
Views: 895
Posted By Bayfly

I would think it would have a valve or flow...

I would think it would have a valve or flow control device on it to be a live well drain, or at least a screen inside to stop from loosing bait?
01-09-2021, 08:04 AM
Replies: 20
Views: 615
Posted By Bayfly

In the past couple of years I have bought some...

In the past couple of years I have bought some screw extractors which have a drill bit on one end and a left hand screw thread on the opposite end of each size. The ones I bought come in two groups,...
01-08-2021, 08:09 PM
Replies: 27
Views: 1,085
Posted By Bayfly

250-300 Sho.

250-300 Sho.
01-05-2021, 07:59 PM
Replies: 28
Views: 8,439
Posted By Bayfly

Great looking rig, but I'm a little surprised you...

Great looking rig, but I'm a little surprised you put a ladder on the transom. You can probably step in the boat from the water if you are on a hard bottom!
01-05-2021, 07:34 PM
Replies: 19
Views: 610
Posted By Bayfly

I installed a Bob's jackplate on my boat when I...

I installed a Bob's jackplate on my boat when I assembled it in '99 and have not had the first problem with it.:thumbsup:
01-03-2021, 09:30 AM
Replies: 62
Views: 5,078
Posted By Bayfly

What is made out of EDPM (synthetic rubber) which...

What is made out of EDPM (synthetic rubber) which functions like a zip tie?
01-03-2021, 08:58 AM
Replies: 3
Views: 313
Posted By Bayfly

The voltage should remain 12V when you switch to...

The voltage should remain 12V when you switch to both, if wired correctly. On the two bank charger, it should have separate positive and negative wires for each bank (battery) and be fused, thus you...
01-03-2021, 08:51 AM
Replies: 10
Views: 596
Posted By Bayfly

The one concern I would have is the weight rating...

The one concern I would have is the weight rating of the lift, due to it not accommodating the length of your boat. Evidently the lift was built for a boat shorter and possibly lighter then your boat?
01-02-2021, 10:09 AM
Replies: 13
Views: 737
Posted By Bayfly

I see this as a good questionnaire to ask your...

I see this as a good questionnaire to ask your surveyor to fill out for you, but the average person who has never maintained a boat would not be able to complete this without assistance. This is not...
01-01-2021, 09:49 AM
Replies: 5
Views: 249
Posted By Bayfly

Algae is something I would not have thought...

Algae is something I would not have thought about, but to check for fuel line compromise you might cut a small section out where you have a connection to learn the codition of the interior.
12-31-2020, 07:46 PM
Replies: 10
Views: 528
Posted By Bayfly

Don't be so lazy and do your research like the...

Don't be so lazy and do your research like the rest of us and buy what fits your fancy!:trout:
12-31-2020, 02:26 PM
Replies: 7
Views: 264
Posted By Bayfly

I have used the Minn Kota chargers for about ten...

I have used the Minn Kota chargers for about ten years, and my latest is the 330 and it's about 3 years old. I'm using it for three Group 31 Duracell AGMs 24/7. My trolling motor is a MG Xi5, but my...
12-31-2020, 10:19 AM
Replies: 6
Views: 350
Posted By Bayfly

Tim (OP), I suggest you contact the manufacturer...

Tim (OP), I suggest you contact the manufacturer of the tester you have acquired and ask to them to inform you of the difference they are concerned with.
12-31-2020, 10:12 AM
Replies: 22
Views: 664
Posted By Bayfly

Vital, why do you reference the fuel tank, as...

Vital, why do you reference the fuel tank, as possibly needing replacement in a couple of years on the Wellcraft? FYI, HPDIs and fuel problems are not compatible. If the engine is a 300 HPDI I would...
12-27-2020, 08:24 PM
Replies: 86
Views: 5,932
Posted By Bayfly

OP, where is this information recorded or...

OP, where is this information recorded or displayed? Thanks for posting your experience with the battery.
12-25-2020, 11:38 AM
Replies: 31
Views: 2,037
Posted By Bayfly

I'm not familiar with your hull, but have owned...

I'm not familiar with your hull, but have owned boats with motors in the range you are referencing. I suggest you have two viable alternatives, either consider a slightly larger engine, maybe a 115,...
12-24-2020, 09:00 AM
Replies: 23
Views: 1,101
Posted By Bayfly

I suggest you get rid of the carpet and put an...

I suggest you get rid of the carpet and put an epoxy coating on the floor.
12-23-2020, 11:29 AM
Replies: 4
Views: 482
Posted By Bayfly

Xfit, if I understand what you are wanting to do...

Xfit, if I understand what you are wanting to do I suggest you wait until you have tried it like it is, because what you are talking about can be added at any time?
My suggestion is made thinking I...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.