Notices
 
Search: Posts Made By: ParatusMS
Showing results 1 to 25 of 500
Search took 0.33 seconds.
03-11-2020, 10:30 AM
Replies: 7
Views: 1,292
Posted By ParatusMS

Exceptional! I'm writing down your method and...

Exceptional! I'm writing down your method and products. Thanks!
Forum: Dockside Chat
03-11-2020, 05:22 AM
Replies: 37
Views: 3,220
Posted By ParatusMS

Daughter's insurance company dropped them because...

Daughter's insurance company dropped them because they didn't have a lock on the backyard privacy fence where the trampoline was...found out when the notice shows up in the mail. They had been...
03-03-2020, 07:11 AM
Replies: 10
Views: 1,377
Posted By ParatusMS

I've used it to make ceviche like in Turks or...

I've used it to make ceviche like in Turks or Bahamas. Same method, but I beat it with a mallet, then chop into small pieces. "Almost" the same in my opinion.
01-16-2020, 05:38 PM
Replies: 3
Views: 230
Posted By ParatusMS

Looking at the schematics....I would suspect...

Looking at the schematics....I would suspect "bearing flange". Go to their website and pull up manual for your motor, schematics are on the last several pages.
01-16-2020, 05:33 PM
Replies: 3
Views: 230
Posted By ParatusMS

I'm no expert....but I did rebuild a 80lb motor...

I'm no expert....but I did rebuild a 80lb motor several years ago. Though, I only replaced the 'tube/magnet' side of the equation. I would recommend going to the MK site and pulling up the...
Forum: The Carolinas
01-16-2020, 05:26 PM
Replies: 10
Views: 4,226
Posted By ParatusMS

Regulator 24XO

Any of you folks priced out one yet? Just poking around, might bite the bullet....but probably not... I'll poke around on the issue this weekend.
01-16-2020, 04:06 PM
Replies: 613
Views: 1,230,881
Posted By ParatusMS

47 years young!!!! It's quite the task keeping...

47 years young!!!! It's quite the task keeping up.
https://cimg3.ibsrv.net/gimg/www.thehulltruth.com-vbulletin/1410x1377/img_0010_b2d483e310d445f9a61986cca5c03fb887092620.jpg
Forum: The Carolinas
01-16-2020, 03:44 PM
Replies: 7
Views: 410
Posted By ParatusMS

^^^^^^That guy!!!!

^^^^^^That guy!!!!
Forum: The Carolinas
01-16-2020, 03:34 PM
Replies: 11
Views: 1,192
Posted By ParatusMS

I have Terrova 36V in 72" shaft on a 4-4.25K lb...

I have Terrova 36V in 72" shaft on a 4-4.25K lb boat. It does great. I run Duracell wet cell 110Ah batteries on a Minn Kota 3bank charger with absolutely no 'power' issues. I have fished three...
12-30-2019, 03:31 AM
Replies: 9
Views: 1,503
Posted By ParatusMS

Most are on YouTube

Most are on YouTube
12-30-2019, 03:23 AM
Replies: 5
Views: 590
Posted By ParatusMS

THOUGHT it was a done deal. After several more...

THOUGHT it was a done deal. After several more days on the water with no issues...…….then I suddenly get a "no GPS signal" display when trying to spot-lock. I remove the head cover to check for...
12-10-2019, 03:39 AM
Replies: 31
Views: 1,138
Posted By ParatusMS

These are from www.domedlettering.com (approx...

These are from www.domedlettering.com (approx $75)

https://cimg6.ibsrv.net/gimg/www.thehulltruth.com-vbulletin/480x640/name_df34f2655788e503b8e4d16a1b9771837ed87726.jpg
12-10-2019, 03:31 AM
Replies: 31
Views: 1,138
Posted By ParatusMS

3DLettering.com: Premade Domed Lettering...

3DLettering.com: Premade Domed Lettering (http://www.3Dlettering.com) or www.domedlettering.com Around $50-ish for a pre-spaced set (both sides) on backing film, depending on font and whatnot...
Forum: Dockside Chat
11-07-2019, 05:57 AM
Replies: 281
Views: 23,664
Posted By ParatusMS

I fun shoot a Bergara HMR in 6.5C using 140gr...

I fun shoot a Bergara HMR in 6.5C using 140gr American Eagle Match and Hornady. Both do exceptionally well out to 500 (haven't shot further yet).
11-06-2019, 03:48 AM
Replies: 11
Views: 1,767
Posted By ParatusMS

Most likely shoulda used one of the aluminum...

Most likely shoulda used one of the aluminum plates available from Robalo to mount that 'puck'. I have a R246 and fabricated my own, and used the 'heavy duty' quick release puck. I don't know if...
10-28-2019, 07:48 AM
Replies: 53
Views: 7,990
Posted By ParatusMS

"Does the new part have a port for the prop shaft...

"Does the new part have a port for the prop shaft cooling water?"

YES
Forum: The Carolinas
10-28-2019, 03:29 AM
Replies: 10
Views: 1,512
Posted By ParatusMS

I use a planer with release clip just above it on...

I use a planer with release clip just above it on occasion for kings, albies, etc. Works like a charm! Just have to handline it back up to reset. Just look for "downrigger"/"planer" release...
Forum: The Carolinas
10-17-2019, 06:55 AM
Replies: 104
Views: 17,771
Posted By ParatusMS

I use #6 plain shank snelled hooks. Tie a loop in...

I use #6 plain shank snelled hooks. Tie a loop in your main line about eighteen inches up from the end, loop the snell into that loop, then tighten them down. Tie another about twelve inches below...
Forum: The Carolinas
10-17-2019, 06:53 AM
Replies: 104
Views: 17,771
Posted By ParatusMS

That didn't work out as planned! Poked around a...

That didn't work out as planned! Poked around a bit and kept four puffers. Perhaps this weekend! Still haven't hit the surf yet, which I'm sure will produce...so may do that instead of the boat...
10-17-2019, 05:44 AM
Replies: 5
Views: 590
Posted By ParatusMS

In my case, I had the remote sitting on the...

In my case, I had the remote sitting on the console, so an inadvertent button push 'shouldn't' be the issue.

However, I went back and cleaned the plug and receptacle again....then used it this...
Forum: The Carolinas
10-11-2019, 10:41 AM
Replies: 104
Views: 17,771
Posted By ParatusMS

I'll be out tomorrow, #6 hooks and fishbites, on...

I'll be out tomorrow, #6 hooks and fishbites, on tied rigs.....no hardware!
10-10-2019, 04:47 AM
Replies: 7
Views: 702
Posted By ParatusMS

I've had 100% success at cross referencing...

I've had 100% success at cross referencing schematic part numbers or searching directly for the part nomenclature and browsing until I find it. Almost, if not, all of the non-glass parts are made by...
10-07-2019, 11:08 AM
Replies: 5
Views: 590
Posted By ParatusMS

UPDATE --- Mk terrova anchor function possible problem

Alright folks, here's what happened. Tell me what ya think.

Sitting on 'anchor function' yesterday for about five minutes when I noticed boat drifting off the spot and noticed the controller...
Forum: The Carolinas
10-07-2019, 08:34 AM
Replies: 104
Views: 17,771
Posted By ParatusMS

Caught four yesterday, 8million pigfish, 4million...

Caught four yesterday, 8million pigfish, 4million pinfish, one sea mullet, and one keep croaker. Beaufort Inlet area, rough as a gator's back, had to keep it in reverse backing into the current to...
10-03-2019, 04:43 AM
Replies: 65
Views: 7,948
Posted By ParatusMS

My 2015 made oil up until about 200 or so hrs. ...

My 2015 made oil up until about 200 or so hrs. After the break-in I ran the dog crap out of it, burying the throttle when getting on plane to 'load it up', ran WOT as often as possible, trimmed up...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.