Notices
 
Search: Posts Made By: BCTony
Showing results 1 to 25 of 500
Search took 0.62 seconds.
07-15-2019, 07:04 PM
Replies: 9
Views: 362
Posted By BCTony

I had similar problems with my Evo3 /WM3 Sirius...

I had similar problems with my Evo3 /WM3 Sirius setup. Working well and then intermittent service with 'Unknown weather device' message and then antennae light not showing on WM3 and no service. Unit...
07-15-2019, 07:00 PM
Replies: 5
Views: 206
Posted By BCTony

I had similar problems with my Evo3 /WM3 Sirius...

I had similar problems with my Evo3 /WM3 Sirius setup. Working well and then intermittent service with 'Unknown weather device' message and then antennae light not showing on WM3 and no service. Unit...
07-14-2019, 02:40 PM
Replies: 3
Views: 285
Posted By BCTony

OP said he had 'depth on bottom machine' so I...

OP said he had 'depth on bottom machine' so I think it just a question of selecting source in the Data Bar through the edit menu.
07-13-2019, 12:15 PM
Replies: 3
Views: 285
Posted By BCTony

It sounds to me that you have the information you...

It sounds to me that you have the information you require depth/temperature available in your network. You may just need to activate your sidebar and edit – selecting and choosing source as necessary.
07-11-2019, 12:09 AM
Replies: 15
Views: 422
Posted By BCTony

Have you checked under Settings>Echo that maximum...

Have you checked under Settings>Echo that maximum depth is set to Unlimited and not set at 1000’ or 400’? If it is set at 1000’ this might explain the issue you are experiencing.
06-30-2019, 05:47 PM
Replies: 3
Views: 231
Posted By BCTony

What sounder did you buy? The NSS12 1st Gen. did...

What sounder did you buy? The NSS12 1st Gen. did not have built in sounder so you will need BSM2/BSM3 or SonarHub or S5100 for sonar.
06-27-2019, 10:48 AM
Replies: 37
Views: 2,403
Posted By BCTony

Not sure what you are saying here. Assume...

Not sure what you are saying here. Assume scrolling issue not fixed?
06-19-2019, 08:13 PM
Replies: 3
Views: 842
Posted By BCTony

I have all three of the transducers you list. For...

I have all three of the transducers you list. For your stated purpose I would suggest 175M or 175H. It is a question of considering the difference in cone-angles - the beam area covered at you...
06-14-2019, 05:54 PM
Replies: 5
Views: 1,300
Posted By BCTony

Thank you.

Thank you.
06-14-2019, 11:47 AM
Replies: 5
Views: 1,300
Posted By BCTony

Thread heading should say 19.1.62.1.108 ...

Thread heading should say 19.1.62.1.108

https://www.thehulltruth.com/marine-electronics-forum/1015584-simrad-s5100-update-10-1-62-1-108-a.html
06-14-2019, 11:29 AM
Replies: 5
Views: 1,300
Posted By BCTony

Editing Thread Header

I have made a typo in a thread header - edit does not allow me to amend. How do I correct / change a thread heading?
06-14-2019, 11:25 AM
Replies: 2
Views: 432
Posted By BCTony

Simrad S5100 Update 19.1.62.1.108

Has the Simrad S5100 latest software update 19.1.62.1.108 resolved the issue of slow scrolling / pinging when using multiple channels?

After experiencing problems with later updates I have stuck...
06-13-2019, 10:05 PM
Replies: 3
Views: 307
Posted By BCTony

Not necessarily because of ping rate - but at...

Not necessarily because of ping rate - but at 2,500' your best result is likely to be from Low Chirp or 50hz.
06-13-2019, 10:30 AM
Replies: 3
Views: 307
Posted By BCTony

Each frequency will have 1kW available but the...

Each frequency will have 1kW available but the ping rate will be halved.
06-10-2019, 10:17 AM
Replies: 4
Views: 235
Posted By BCTony

I have had this with Evo3. Same message and then...

I have had this with Evo3. Same message and then it was OK for a while and then not operating and it was found my WM-3 had become defective and replaced under warranty
06-09-2019, 05:41 PM
Replies: 4
Views: 316
Posted By BCTony

Pages>Settings>Echo>Transducer>Search Depth =...

Pages>Settings>Echo>Transducer>Search Depth = 400/1000/Unlimited. Set to Unlimited unless you know you are never going to be in more than 1000'.
06-07-2019, 09:52 PM
Replies: 10
Views: 452
Posted By BCTony

You could always experiment and be a guinea pig...

You could always experiment and be a guinea pig for the rest us - try a B75H in a wet box and report results. Trouble is these CHIRP transducers even at entry level are not inexpensive.
06-03-2019, 10:10 PM
Replies: 6
Views: 1,143
Posted By BCTony

I had a problem recently when updating with a...

I had a problem recently when updating with a well used SD card. Went to update and received message that update file was corrupt. Formatted SD card and reloaded software to the card from same source...
06-03-2019, 08:57 AM
Replies: 8
Views: 504
Posted By BCTony

Looks like electrical interference to me.

Looks like electrical interference to me.
06-02-2019, 08:37 PM
Replies: 23
Views: 738
Posted By BCTony

Have you asked them?

Have you asked them?
06-02-2019, 08:04 PM
Replies: 23
Views: 738
Posted By BCTony

https://cimg3.ibsrv.net/gimg/www.thehulltruth.com-...

https://cimg3.ibsrv.net/gimg/www.thehulltruth.com-vbulletin/1920x1080/screenshot_2019_06_02_19_01_26_a6f679470a5a6546bdb8812679c9675fff8ab24a.png
As posted earlier I have had problems with WM3 and...
06-02-2019, 09:02 AM
Replies: 23
Views: 738
Posted By BCTony

[/left] Well - that is reassuring! We'll see.

[/left]
Well - that is reassuring! We'll see.
06-01-2019, 06:15 PM
Replies: 23
Views: 738
Posted By BCTony

After a year of service my WM-3 failed over the...

After a year of service my WM-3 failed over the last few weeks and has been replaced under warranty.
06-01-2019, 06:12 PM
Replies: 18
Views: 4,454
Posted By BCTony

I am in the fortunate position of having 265LH,...

I am in the fortunate position of having 265LH, 175M and 175HW. Down to 200’ I will usually deploy HW for its wide angle beam and superb performance detecting targets in the water column, but, even...
05-28-2019, 07:44 PM
Replies: 5
Views: 482
Posted By BCTony

Evo3 = Setting>Vessels>Icons

Evo3 = Setting>Vessels>Icons
Showing results 1 to 25 of 500
 


 
Forum Jump