The Hull Truth - Boating and Fishing Forum - Search Results

Notices
 
Search: Posts Made By: TTaxi
Showing results 1 to 25 of 500
Search took 0.24 seconds.
Yesterday, 07:35 PM
Replies: 1
Views: 88
Posted By TTaxi

This lists what is claimed to be equivalent part...

This lists what is claimed to be equivalent part numbers:
https://www.hesta.pl/en/accessories-and-spare-parts-to-fridges/477-12v-electronic-control-unit-for-compressor-danfoss-bd2-bd25-bd3-4-pin.html
Forum: Northeast
08-12-2020, 09:45 PM
Replies: 4
Views: 175
Posted By TTaxi

Not in MA , but as a very remote long shot you...

Not in MA , but as a very remote long shot you might try calling Lauderdale Speedometer , Compass and Repair. The 1 time I asked them to repair an Aetna digital tach, the were friendly, helpful...
08-12-2020, 09:16 PM
Replies: 24
Views: 687
Posted By TTaxi

Did you think to carefully taper -tape both ends...

Did you think to carefully taper -tape both ends of the connection for least resistance going past or back around/through obstructions and holes? Wire used to securely connect hose and cord makes a...
08-12-2020, 02:29 PM
Replies: 5
Views: 139
Posted By TTaxi

When the problem manifests, try a power balance...

When the problem manifests, try a power balance test, removing and grounding one plug wire at a time . If that cylinder has been combusting properly , rpm should drop by roughly 1/8 . If rpm remains...
08-12-2020, 02:03 PM
Replies: 24
Views: 687
Posted By TTaxi

Do you have an inspection cam with monitor yet? ...

Do you have an inspection cam with monitor yet?

If you can find ANY path large enough to get through with the electrician's snake ( I use a 25' coil of aluminum ground wire for old type TV...
08-12-2020, 01:44 PM
Replies: 6
Views: 144
Posted By TTaxi

https://www.replacementboatparts.com/scupperflappe...

https://www.replacementboatparts.com/scupperflappers.aspx

Or check auto parts stores for various thicknesses of rubber gasket sheet. At least 1 boat at my marina dock uses that. and it works...
08-11-2020, 09:56 PM
Replies: 0
Views: 238
Posted By TTaxi

Now You Can Have A Switch...

Perfect for those 1st dorsal fin sightings of the trip:

Install this switch :
https://newwiremarine.com/product/bigger-boat-contura-v/
That turns on THIS:
https://jaws-theme.mp3quack.com/
...
08-11-2020, 09:00 PM
Replies: 10
Views: 225
Posted By TTaxi

You don't say what series Carling rocker switches...

You don't say what series Carling rocker switches you are trying to match, but I don't see that (On)-On-Off configuration offered in any of the illuminated "full-size" series. Closest is always...
08-11-2020, 07:53 PM
Replies: 12
Views: 396
Posted By TTaxi

Re: those protruding screws- Someday someone...

Re: those protruding screws- Someday someone may well rip their arm or hand open on them . I'd replace with appropriate-head SS machine screws, small washer & thin nut with thread lock and grind...
08-11-2020, 07:39 PM
Replies: 2
Views: 133
Posted By TTaxi

A few things to chew on: Suggest you scan...

A few things to chew on:

Suggest you scan the ECM for coded faults which might be triggering safe /slow mode.
( If using a Rinda Technologies' Techmate Pro handheld or Marine Diacom software you...
08-11-2020, 06:18 PM
Replies: 4
Views: 157
Posted By TTaxi

Does it steam at all rpm? The poppets normally...

Does it steam at all rpm? The poppets normally only open under flow pressure at elevated rpm.

Check the water pump 1st.
08-10-2020, 09:07 PM
Replies: 15
Views: 536
Posted By TTaxi

Same with a skier digging in to a turn way off...

Same with a skier digging in to a turn way off to the side of the wake with the boat higher out of the water at speed. That is a LOT of leverage on the T- top support & hull pulling to the side...
08-10-2020, 08:11 PM
Replies: 13
Views: 310
Posted By TTaxi

They just require a flexible hose section between...

They just require a flexible hose section between the solid lines and vibrating parts ,i.e., anything on the engine. And mounting clamps at a specific minimum measurement interval too, I believe.
08-10-2020, 08:04 PM
Replies: 10
Views: 253
Posted By TTaxi

Taking a closer look at your pic, the top of...

Taking a closer look at your pic, the top of the back of the control handle does have a visible bevel to it & a wedge of open space behind it as if it ....could... be designed to swing out from...
08-10-2020, 07:09 PM
Replies: 4
Views: 300
Posted By TTaxi

Not only would I not put both bilge pumps on the...

Not only would I not put both bilge pumps on the same circuit and switch, I definitely would not have both of them wired to the same battery.. If you have both on same circuit and battery you...
08-10-2020, 04:31 PM
Replies: 24
Views: 467
Posted By TTaxi

I agree with Raybo,- rotate sender flange 1/2 of...

I agree with Raybo,- rotate sender flange 1/2 of 1 spacing, mark holes, and drill new holes small enough dia. to accept a tap the dia. size & pitch of the usual fasteners.( not sure of that size.)...
08-09-2020, 11:27 PM
Replies: 19
Views: 501
Posted By TTaxi

What 30West and dsharp said. Steam could be...

What 30West and dsharp said.

Steam could be caused by a leaking head gasket or possibly cracked block but the engine would run noticeably poor. 99% of the time cause is insufficient RW flow so the...
08-09-2020, 10:00 PM
Replies: 6
Views: 131
Posted By TTaxi

Might the available EN version of the NSS Evo2 ...

Might the available EN version of the NSS Evo2 19.1 update addendum offer the same information?
08-09-2020, 09:36 PM
Replies: 9
Views: 291
Posted By TTaxi

:grin: I'm thinking in your case a nice old...

:grin: I'm thinking in your case a nice old windshield may be more useful than a shiny new ( blue card) compass.

But I do prefer/ recommend the flat card type like that F-82 over front-read...
08-09-2020, 09:01 PM
Replies: 3
Views: 144
Posted By TTaxi

Depends on your engine. I would install...

Depends on your engine.

I would install according to the sequence in the parts diagram that is specifically for your exact full model # and serial # engine.
If your diagram above really...
08-09-2020, 08:36 PM
Replies: 10
Views: 253
Posted By TTaxi

I too would expect the handle to be removable,...

I too would expect the handle to be removable, via set screw or perhaps pulling straight out past a catch lip.

But is there any chance flow (not temp) is controlled by swinging the bottom of...
08-09-2020, 08:12 PM
Replies: 1
Views: 70
Posted By TTaxi

Does it have a lanyard kill switch you can test? ...

Does it have a lanyard kill switch you can test? If so, missing lanyard key or bad switch can allow cranking but not ignition.

An appropriate marine diagnostic scan device and adapter could tell...
08-09-2020, 07:36 PM
Replies: 2
Views: 151
Posted By TTaxi

This ad says their H/S brochures are sold out,...

This ad says their H/S brochures are sold out, but you can zoom on the thumbnail pics to view the specs and perhaps copy/save/zoom > print. ...
08-09-2020, 07:22 PM
Replies: 9
Views: 291
Posted By TTaxi

if you otherwise like the style and condition of...

if you otherwise like the style and condition of your Danforth, just pull out the bulb and color it with your choice of permanent markers, reinstall it, done.
I kind of prefer blue over red or...
08-09-2020, 06:57 PM
Replies: 13
Views: 310
Posted By TTaxi

What prowlerfish said. Relatively few boats...

What prowlerfish said.

Relatively few boats with twin gas engines and twin tanks will draw down tanks remotely evenly with a crossover valve open. And if 1 tank runs empty or 1 tanks pickup...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.