Notices
 
Search: Posts Made By: Knot Tight
Showing results 1 to 25 of 500
Search took 0.56 seconds.
Yesterday, 01:09 PM
Replies: 7
Views: 453
Posted By Knot Tight

Thatís one of several power techs I have seen...

Thatís one of several power techs I have seen that happen to. Email them and they will
replace it. I wonít run a set of them on a big boat at this point. Seen it too many times.
11-30-2020, 07:02 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

I sold my boat about this time last year thinking...

I sold my boat about this time last year thinking the hhh would move along faster plus the hours were running up quickly. I ended up buying another boat so I could fish this season
and sold it in...
11-27-2020, 05:37 AM
Replies: 325
Views: 49,902
Posted By Knot Tight

Congratulations Tim, enjoy the boat she turned...

Congratulations Tim, enjoy the boat she turned out awesome. Let me know what you think about that lift setup after using if a few times.
11-22-2020, 03:02 PM
Replies: 18
Views: 842
Posted By Knot Tight

As of mid 2017 they would build the hulls stepped...

As of mid 2017 they would build the hulls stepped or not. The step was an option which the majority of ordered were stepped.
11-22-2020, 10:45 AM
Replies: 18
Views: 842
Posted By Knot Tight

There is no 30v. The 30T is the non stepped...

There is no 30v. The 30T is the non stepped version of the 30St. There are also 27 opens that people call 30Tís but they are totally different. I believe the 30T came out in 2008ish and it has a...
11-19-2020, 05:54 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

I think 3-4 months is doable given some...

I think 3-4 months is doable given some additional room to build boats with nothing slowing down the pipeline of supplies. Shaneís boat and mine are going to be pretty similar which should help some...
11-18-2020, 11:21 AM
Replies: 325
Views: 49,902
Posted By Knot Tight

I am not a fan honestly of the door design...

I am not a fan honestly of the door design either. I think it will likely lead to issues just based on leverage alone. I think the best solution would be to not have the shelf where the rodholders...
11-16-2020, 06:11 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

Both seatrials I have been on the boat runs very...

Both seatrials I have been on the boat runs very linear through the rpm range and on both of them the boat ran great in the highspeed trolling range which for me is in the 16-20 knot range. The plug...
11-15-2020, 07:09 AM
Replies: 325
Views: 49,902
Posted By Knot Tight

Congratulations Tim, sheís a beauty. I am glad...

Congratulations Tim, sheís a beauty. I am glad your boat will be gone next time I go down. I donít want my wife to get any ideas from all your options. That door is awesome, lots of detail and...
11-12-2020, 02:43 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

That lift setup looks awesome, how are they...

That lift setup looks awesome, how are they attached to the cross bunks? I am going to need a set of those also. The only thing I would maybe do different is to have some kind of transition in the...
11-12-2020, 06:51 AM
Replies: 325
Views: 49,902
Posted By Knot Tight

Tim that was a very kind offer of you. I would...

Tim that was a very kind offer of you. I would love to see the data before making the commitment but I think the 300ís are going to be an excellent match. It will be interesting to see what your...
11-12-2020, 04:59 AM
Replies: 325
Views: 49,902
Posted By Knot Tight

Mark I think the 300 v8ís are going on the back...

Mark I think the 300 v8ís are going on the back of mine barring a new release of a 350 from Yamaha or merc. I do Bahamas trips and the supercharged verados donít seem to like the poor fuel quality...
11-11-2020, 05:57 PM
Replies: 226
Views: 21,834
Posted By Knot Tight

I am sure you could find one somewhere but not in...

I am sure you could find one somewhere but not in Florida at any of the distributors. I looked for a pair a few months ago.
11-11-2020, 05:16 AM
Replies: 226
Views: 21,834
Posted By Knot Tight

The merc v8 has already been turned into a 360. ...

The merc v8 has already been turned into a 360. It took 7000 rpms and 91 octane fuel to make it happen though.

https://www.mercuryracing.com/outboards/engines/360apx/
11-07-2020, 04:13 PM
Replies: 16
Views: 1,164
Posted By Knot Tight

I didnít see I impressive numbers on our seatrial...

I didnít see I impressive numbers on our seatrial even in the river. It was blowing 15 plus and in the ocean it was wet from both spray from the side and a lot of sneeze from the tunnel. It was...
11-03-2020, 05:34 PM
Replies: 20
Views: 1,618
Posted By Knot Tight

That sounds about right for that boat. South...

That sounds about right for that boat. South Florida and the Panhandle have some of the worst rates.
11-03-2020, 05:31 PM
Replies: 9
Views: 1,031
Posted By Knot Tight

Exhaust manifolds, the good thing is you found it...

Exhaust manifolds, the good thing is you found it but the bad is they are nearly $700 each and each motor has 2.
11-02-2020, 07:22 PM
Replies: 40
Views: 2,909
Posted By Knot Tight

No problem, mine ventilated the block which is...

No problem, mine ventilated the block which is the most valuable piece. Even running they donít sell for more than 8k or so in that age range.
11-02-2020, 05:29 PM
Replies: 40
Views: 2,909
Posted By Knot Tight

I sold a blown 350 earlier this year for 4k and...

I sold a blown 350 earlier this year for 4k and threw in an extra lower unit. It was actually blown and not rebuild able.
10-28-2020, 06:19 PM
Replies: 6
Views: 504
Posted By Knot Tight

I priced out a 189 a few years back and I would...

I priced out a 189 a few years back and I would guess you would be lucky to get out the door under 100. By memory I was over 70 for a 189 carbon Kevlar. I have had a 189 for 7 years, the boat has...
10-28-2020, 06:04 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

[QUOTE=Lazy Bones;14174567]1. Pretty sire we ran...

[QUOTE=Lazy Bones;14174567]1. Pretty sire we ran into yíall in Grand earlier this summer.
looking forward to your build.

Yes sir that was us, hopefully we will get to spend some more time over...
10-28-2020, 05:04 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

They are not related. Shane is correct on the...

They are not related. Shane is correct on the cockpit length. We were both going to go with the center well option but honestly there is plenty of room with the twin livewell option and it leaves a...
10-25-2020, 04:10 PM
Replies: 325
Views: 49,902
Posted By Knot Tight

Well written and absolutely true. I try not to...

Well written and absolutely true. I try not to talk to Heath too much about my build but he picks up the phone or responds quickly if I have a question. The build quality is over the top and he...
10-22-2020, 05:03 PM
Replies: 10
Views: 490
Posted By Knot Tight

Every used boat I have purchased over 3 years old...

Every used boat I have purchased over 3 years old has come with a surprise even if it was surveyed and thatís over 20 boats. Yours is a relatively easy and inexpensive repair, fix it and move on.
10-21-2020, 05:06 AM
Replies: 25
Views: 1,123
Posted By Knot Tight

My last boat had an stand thru tower and a open...

My last boat had an stand thru tower and a open array and the next one will also. For birds the radar will be invaluable, for debris, weedlines, slight rips/ color changes etc. the stand thru top...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.