Notices
Like Tree1Likes
  • 1 Post By copem1

C10 Setup Question

Reply

Old 04-15-2018, 09:29 AM
  #1  
Admirals Club Admiral's Club Member
Thread Starter
 
Join Date: Dec 2009
Posts: 171
Default C10 Setup Question

Just rigged a new to me pair 2015 DF300's. I upgraded to C10 displays with V3.5 interface cables. I set the displays for twin set up and did the initialization with BRP 8.0 diagnostic software. Only the port motor will display info. I can start both motors but no signal from starboard motor. I uploaded latest software version from Navico and installed in both displays and swapped interface cables with no luck. Any advise is appreciated. Thanks

Marc
copem1 is offline  
Reply With Quote
Old 04-15-2018, 10:01 AM
  #2  
Senior MemberCaptains Club Member
THT sponsor
 
Outboard Specialties's Avatar
 
Join Date: Jan 2007
Location: Pompano Beach, FL
Posts: 1,718
Default

You have to set one of the engine interfaces to stbd, the default is port from the factory. Go into menu, settings, then system, then network, then device list, you should see 2 port engine interface, configure one of them to stbd. That should take care of your issue.
Outboard Specialties is offline  
Reply With Quote
Old 04-15-2018, 12:28 PM
  #3  
Admirals Club Admiral's Club Member
Thread Starter
 
Join Date: Dec 2009
Posts: 171
Default

Thanks for the quick reply.
copem1 is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description: