Plug for Eric Kent/ KentFAB Center Console Radar Arch
08-23-2019, 09:25 AM
#1
Admirals Club 
Thread Starter
Plug for Eric Kent/ KentFAB Center Console Radar Arch
Just a little praise for Eric and his guys who were able to crank out an awesome radar arch for me earlier this year. He made it quick and did it pretty much perfectly after a couple conversations and some pictures I collected, most of which he had actually built. Its a little odd and not for everyone (vs. a T-Top) but I think they fit the smaller center consoles in the NE pretty well. The amount of times I want/ need to fish from the wheel, combined with the newbs slamming rods off an oversized T-Top made this a no brainer.
Rigged it up with lights, antennas, and an 18" Garmin and it's been a total game changer. I'm going to throw some pictures here in case someone else is making the same decision!
Rigged it up with lights, antennas, and an 18" Garmin and it's been a total game changer. I'm going to throw some pictures here in case someone else is making the same decision!
Last edited by tomharty; 08-23-2019 at 09:48 AM.
Likes:
08-25-2019, 03:38 PM
#6
Admirals Club
Thread Starter
Originally Posted by AlloyToy
Nice! Gonna do some curtains around it too?
08-26-2019, 10:49 AM
#8
Senior Member
I'm in Plymouth and just took my t-top off and am now looking for a console grab rail to go around my windshield...will probably end up having one made.
Can you share what you paid for this?
Can you share what you paid for this?
08-26-2019, 08:48 PM
#9
Originally Posted by Hops143
I'm in Plymouth and just took my t-top off and am now looking for a console grab rail to go around my windshield...will probably end up having one made.
Can you share what you paid for this?
Can you share what you paid for this?
09-03-2019, 02:39 PM
#12
Member
I had them build me a custom replacement fuel tank 4 years ago. They built an exact replica from a sketch and measurements. The new tank was actually constructed better than the original. Fantastic work by these guys.
09-03-2019, 06:43 PM
#13
Originally Posted by thejtdude
I had them build me a custom replacement fuel tank 4 years ago. They built an exact replica from a sketch and measurements. The new tank was actually constructed better than the original. Fantastic work by these guys.
