Go Back  The Hull Truth - Boating and Fishing Forum > mazzuca
Reload this Page >

Conversation Between mazzuca and Kevinwwings2

Notices
Conversation Between mazzuca and Kevinwwings2
Showing Visitor Messages 1 to 3 of 3
  1. mazzuca
    07-26-2015 05:59 AM
    Thank you Kevinwwings2,

    I think I will follow with the same solution. Do you happen to know where I can buy the b260 without the faring block?

    Thank you again, Daniel
  2. Kevinwwings2
    07-17-2015 08:50 AM
    My boat was built with the B260 Glassed into the hull, there for I had no use for the Fairing block. I just had to remove the glassed in ducer and install a new one. I can say that Gill actually suggests the fairing block as opposed to glassed in. I have a feeling if it isn't glassed in just right it doesn't work well, but the fairing block leaves some room for error.
    I was actually able to buy the ducer without the fairing block and it saved me some $ on the new ducer. In my case I had no use for it, and if I wanted to use the fairing block I would have to have mounted it off to the side and either leave the old ducer in or remove it and fill the hole. My boat lives on a trailer which can cause problems with fairing blocks if they are not placed just right. In my case I have room for either but in my eyes working with what I had was much easier than repairing and making new holes.
  3. mazzuca
    07-16-2015 06:34 PM
    Hi

    I saw your B260 installation post and have one question. Why don´t you install the fairing block included with the B260 ?

    Thank you , Daniel