Erobinson1 Erobinson1 is offline

Senior Member

About Me

  • About Erobinson1
  • Signature
    Flats & Bay 18x8 Yamaha 115
    Hydra-Sports 2390 Vector E-tec 250
    Grumman 1648 Merc 50
    SeaPro 1900cc 135opti-sold
    Ranger 374 Mariner 175EFI-sold
    HydraSports x270 Mariner MagII-sold
    Dawson 18 Mariner 150-sold
    Ranger 16 Merc 85-sold


Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: Today 03:54 PM
  • Join Date: 06-02-2012
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. 05-01-2014 06:46 PM
    They are 4' fluorescent tube protectors from Home Depot. They're kinda thin but much cheaper
    Than extruded acrylic. For a homemade project I think they're fine. These are 12v. No xformer
    Needed. These pics are wired to a small battery out of my sons 4 wheeler. I'm gonna wire a plug
    To the end so I can plug them into my marinco elec reel plug. I am gonna pour the next one full of
    2 part clear "bar top" finish to see how that works out.
  2. 05-01-2014 04:20 PM
    Where did you purchase the clear polycarbonate tubes from? Great job. You don't need any transformers like shown on the ebay ad do you? Just hook up to 12v batt.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.