Second Station on/off wiring
12-26-2018, 06:33 AM
#1
Junior Member
Thread Starter
Join Date: Apr 2016
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Second Station on/off wiring
Need some help from the gurus:
I installed a second station on my Parker 2320 sport cabin with a single 2013 F200 yamaha. I installed bocatech's momentary switches that I spliced on the down side of the harness for "start"
but having an issue of what to hook into for the "stop" (like a kill switch). I know that the white wire on the harness is the kill wire--But if out of the bocatech switch that has 3 wires (12V, Load, and Ground) how should I go about hooking up the switch to get the function of using the switch to shut off the engine from the second station.
Many Thanks
I installed a second station on my Parker 2320 sport cabin with a single 2013 F200 yamaha. I installed bocatech's momentary switches that I spliced on the down side of the harness for "start"
but having an issue of what to hook into for the "stop" (like a kill switch). I know that the white wire on the harness is the kill wire--But if out of the bocatech switch that has 3 wires (12V, Load, and Ground) how should I go about hooking up the switch to get the function of using the switch to shut off the engine from the second station.
Many Thanks
12-26-2018, 07:52 AM
#2
Senior Member
the stop signal for a Yamaha, is the white wire connected to ground.
12-26-2018, 09:25 AM
#4
Senior Member
Originally Posted by Fwpratt
the stop signal for a Yamaha, is the white wire connected to ground.
Originally Posted by nhivan22
No, the white wire is in the 10 pin harness.
to stop a Yamaha from running, connect the white wire that is in the 10 pin harness to ground.
(this is what the key switch does when "off", and the lanyard switch when "pulled")
to allow a Yamaha to run, assure that the white wire of the 10 pin harness is not grounded.
Last edited by Fwpratt; 12-26-2018 at 09:38 AM.
