Notices

C10 Gauge not receiving engine data

Old 12-02-2017, 10:47 AM
  #1  
Admirals Club Admiral's Club Member
Thread Starter
 
Join Date: Jun 2013
Posts: 640
Default C10 Gauge not receiving engine data

have a 2017 DF300APX and C10 gauge. The gauge worked perfectly yesterday. Today it doesn't show the rpm, voltage, trim level, or any other engine data. It does show speed and depth from my Garmin fishfinder on the Nmea 2000 network. The Garmin shows rpm, and fuel burn rate. Any ideas what is going on? I disconnected the network T for the gauge and reconnected it.
NRGarrott is offline  
Old 12-03-2017, 01:00 AM
  #2  
Admirals Club Admiral's Club Member
Thread Starter
 
Join Date: Jun 2013
Posts: 640
Default

I disconnected the entire nmea 2000 network and cleaned each T and cable with Electronic contact cleaner. It still didn't work, so I swapped the C10 connectors position on the backbone, it still didn't work. I found a thread from July '17 where someone said to hold the up and down arrows at the same time while turning the gauge on for a reset. That did appear to work. I'm going offshore tomorrow for stripers and I guess we will find out.
NRGarrott is offline  
Old 12-03-2017, 04:03 AM
  #3  
Admirals Club Admiral's Club Member
 
Join Date: Feb 2008
Location: Jupiter, FL
Posts: 536
Default

Usually the easiest way to get data back to the C-10 gauge is to go into network settings on the C10 gauge and select "auto select" under "devices". Make sure you are using software version 3.5 of the Suzuki interface cable that connects to your NMEA 2000 network, you may have an old version causing the C-10 gauge to drop data. The C-10 gauge will continue to randomly drop data if your Suzuki interface software version is not correct for your engine.
pulp friction is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread