Notices
Marine Electronics Forum

AP 22 and Raymarine C series

Old 11-19-2016, 12:29 PM
  #1  
Junior Member
Thread Starter
 
Join Date: Nov 2016
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default AP 22 and Raymarine C series

I have a Robertson AP 22 which when powered on via the control unit shows some text, beeps and then in less than a second goes blank/dead. This happened first after trying to start the engine with a low battery while all instruments were turned on. Forgot to switch batteries. This may be a red herring.
Second problem, my Raymarine C 60 is not radaring. Just got up one day switched on plotter, switched on the radar and the message " no input" (or something like that) appeared. I measured the values at the cable from radar to plotter and all values were good. Strange thing is when I put my plotter on my friends boat which has a Raymarine C 120 it reads his radar and when I put his plotter on my boat it reads my radar fine. His plotter is running an earlier software, the radar arrays are running different software too. Any ideas. Jim
Old 11-19-2016, 02:38 PM
  #2  
Admirals Club Admiral's Club Member
THT sponsor
 
Join Date: Jul 2010
Posts: 5,499
Received 528 Likes on 306 Posts
Default

We may be able to help on one or both of these, feel free to go to our website and fill out a repair center request if you want to send these for repair. Ap22 is either a head issue or a j box issue. C80?issue sounds like a bad board but possible it can be corrected with a factory reset or upgraded software

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.