Notices
Marine Electronics Forum

Dash Re-Design

Old 11-10-2016, 01:59 PM
  #1  
Senior Member
Thread Starter
 
Join Date: Jan 2015
Location: Nelson, New Zealand
Posts: 944
Received 41 Likes on 25 Posts
Default Dash Re-Design

I want to re-Build my dash to accommodate a flush mounted HSD-7. You will see below that due to to having twin, older outboards my dash is quite packed.

The VHF is flush mounted on a 6" vertical panel out of shot above the dash (you can see the cord hanging down in the photo). This was a stupid decision.

I would like some feed back on my ideas for re-configuration: -

Replace VHF with a black box unit located forward from the other electrics and mount the hand piece/control on the port side of the helm.

I'll make a surround for the HDS-7 that attaches to the dash and the VHF panel to position the screen at best viewing angle. I'll fit the Tacho's either side of this on the VHF Panel.

Volts and Hours to the vertical surfaces either side of steering wheel base.

DC switch panels below them.

Trims to bottom centre of new dash. Bilge panels either side of them.

Lose the speedo
Attached Images  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.