Notices
Marine Electronics Forum

Transducer Cable Question? Sealant?

Old 09-20-2004, 03:20 PM
  #1  
Senior MemberCaptains Club Member
Thread Starter
 
Join Date: May 2004
Location: Myrtle Beach, SC
Posts: 779
Likes: 0
Received 4 Likes on 2 Posts
Default Transducer Cable Question? Sealant?

I have a transducer on the back of my boat that I managed to break away from the bracket during a really bad day of fishing. When the bracket let go, the ducer ripped out the two screws with plastic attachments to the calbe holding it tight to the boat. It also pulled the cable through the clam shell and stripped part of it.

I was planning on pulling off the clam shell and pulling out the sealant and then restuffing after taping the stripped part of the cable. Just wondering if 4200 was a good sealant to use or another is better. The clam shell is just above the water line.

Thanks for any input.

Fred
Contender23 is online now  
Old 09-20-2004, 11:51 PM
  #2  
Junior Member
 
Join Date: Jul 2004
Location:
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Transducer Cable Question? Sealant?

If its above the water line any sealant should do its just to keep the splashes out isnt it?
davros is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.