Go Back  The Hull Truth - Boating and Fishing Forum > BOATING FORUMS > Marine Electronics Forum
Reload this Page >

Installation tips for electronics box requested

Notices
Marine Electronics Forum

Installation tips for electronics box requested

Old 03-31-2003, 05:31 AM
  #1  
rs
Member
Thread Starter
 
Join Date: May 2002
Location: Lebanon, Ohio
Posts: 40
Likes: 0
Received 0 Likes on 0 Posts
Default Installation tips for electronics box requested

I'm going to be installing a VHF radio in my (fiberglass) electronics box. I'm looking for recommendations on how to run the antenna wire. I was thinking of running it out the side of the box and using a clam shell to cover the hole. Any comments or other suggestions?
rs is offline  
Old 03-31-2003, 05:52 AM
  #2  
Senior MemberCaptains Club Member
 
Join Date: Nov 2002
Location: Bermuda
Posts: 351
Likes: 0
Received 1 Like on 1 Post
Default Installation tips for electronics box requested

I ran mine out of the side of the box. I drilled, installed a rubber grommet and then ran the VHF wire into the box. It's a very tight fit and have not gotten any water get in.

On the other side of the box I have the same set up to get a power wire up from the console to the electronic box and the AM/FM ant.

VHF and Stereo with speakers are in the electronic box and both antenaes are mounted on top of the T-Top.
BestMate is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.