Go Back  The Hull Truth - Boating and Fishing Forum > BOATING FORUMS > Marine Electronics Forum
Reload this Page >

Running wires through T-top tubes (Problem)

Notices
Marine Electronics Forum

Running wires through T-top tubes (Problem)

Old 04-20-2004, 12:44 AM
  #21  
Senior MemberCaptains Club Member
 
Join Date: Mar 2004
Location: Edgewater, NJ
Posts: 4,706
Likes: 0
Received 4 Likes on 4 Posts
Default RE: Running wires through T-top tubes (Problem)

I had the same problem. I wish I had found this earlier and saved you some cash and time . I had the same problem, but I had a hole in the console where the originals tandoff was. I poked around with a wire and found it did have a hole into the main tube. I went to the top drilled a 1/2 hole tried to fish wire it like hell. Spent a good few days at it. Finally I gave up and ran the wire's out side and tied it off. I started to clean upthe deck and got my shop vac. As I was cleaning I sucked in a piece of string thru a tube and it was kinda stuck half way in the tube nad half in the vac hose. Eureka!. I tied a small washer to a piece of 100# spider wire, ran it as far as I could drop it, and put the shop vac on the hole at hte inside of the console. After jiggleing the string for a bit. I felt it go right into the vac. Now I have 2 VHf anntena and all vhf wires running on the portside tube and lgiht and gps wires on the sb side.
DarthBaiter is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.