Notices
Marine Electronics Forum

VHF noise and plug question

Old 09-22-2008, 02:24 PM
  #1  
Member
Thread Starter
 
Join Date: Dec 2004
Location: Channel Islands, CA
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
Default VHF noise and plug question

I have a 1997 merc 115hp that I took out today for the first time since I changed my plugs. I called a few marine repair yards and they told me the correct plug to use for my engine is an NGK BP8H-N-10.

So I picked up 4 of these and installed them. Engine runs much better but now I'm getting noise through my radio from the motor. I was reading about this and someone recommended to get resistor type plugs.

Are the plugs I bought these resistor type? If not, which ones do I need to buy?

Any advice on getting rid of the noise on my VHF?

Thanks
Old 09-23-2008, 07:18 AM
  #2  
Member
 
Join Date: Sep 2008
Location: Tigard Oregon
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
Default Re: VHF noise and plug question

Only way will be to get resistor plugs or wires. Without them you have created one of the first modes of radio communication - Spark Gap.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.