Notices
Marine Electronics Forum

Installing 3006c bundle

Old 04-08-2007, 10:28 AM
  #1  
Junior Member
Thread Starter
 
Join Date: Mar 2002
Location: MICHIGAN
Posts: 13
Likes: 0
Received 0 Likes on 0 Posts
Default Installing 3006c bundle

Good morning,

I am getting ready to install my garmin bundle and have a couple of questions. I never installed electronics before but after reading this forum I thought I would give it a shot. Here is what I plan to do. I currently have 3 open slots in my dc panel. One slot for radar, one for chartplotter,and one for a electronics accessory. I plan on running the radar to one, chartplotter to the other and put the xm,transducer and another chartplotter on the accy. With the accy I plan on putting a fuse block and running all three to it. Does this sound right and what gauge of wire do I need? Also, Do I need to keep the inline fuses if I have a fuse block installed? In regards to the chartplotter garmin only gives you 6ft of power cable. Can I add length with 14 ga wire to the dc panel or should I go with 10ga. The length I need is about 18ft. One more questions is if you have the radar on a seperate fuse do you still need an inline fuse? same goes with the chartplotter. Any help or advice would be great!

Thanks

Will

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright © 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.