Notices
Marine Electronics Forum

FYI Cutting Cables in a C120 Raymarine

Old 03-25-2007, 03:57 AM
  #1  
Senior MemberCaptains Club MemberPLEDGER
Thread Starter
 
Join Date: Jan 2004
Location: Portsmouth, RI 02871
Posts: 2,059
Likes: 0
Received 0 Likes on 0 Posts
Default FYI Cutting Cables in a C120 Raymarine

Just installed a C120 on the roof of a Hardtop in an upside down Navpod. The pulling of the wires was a PIA. I cut the DS300 wire that runs from the DS300 unit to the C120 so I would not have to drill 3/4" holes. I do not think I could have snaked the connector past some of the bends. If it didn't work I was going to buy a 10M cable because the one I had was too short.

When you cut the wire Solder the wires and heat shrink them. Don't forget the shield. There are only 2 wires in this cable... 3 counting the braided shield... I also extended it 3'


PS... The Navpod's are not reversible so if you want to put one upside down it is a different part number

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.