Vetus 95kg - Second station
10-11-2020, 07:03 AM
#1
Admirals Club 
Thread Starter
Vetus 95kg - Second station
This may be an obvious answer to some but I’m struggling to find clear cut info online.
Can anyone confirm that I can have two controls for this, one at helm and one on my tower? Right now I only have controls at my helm but would love them up top. If possible, what is needed? All I can find is a y-harness online. Thanks
Can anyone confirm that I can have two controls for this, one at helm and one on my tower? Right now I only have controls at my helm but would love them up top. If possible, what is needed? All I can find is a y-harness online. Thanks
10-12-2020, 06:33 PM
#2
Senior Member
Join Date: Dec 2002
Location: Fort Myers Beach, FL, USA
Posts: 3,514
Received 533 Likes
on
341 Posts
I think the middle diagram on the right side of page 23 shows two control panels. Vetus Installation
Electrically, you have two switches in parallel, and either can control the thruster.
You should also be able to install a remote receiver and use a key fob remote from the tower, or other locations onboard.
Electrically, you have two switches in parallel, and either can control the thruster.
You should also be able to install a remote receiver and use a key fob remote from the tower, or other locations onboard.
10-13-2020, 06:51 PM
#3
Admirals Club
Thread Starter
Yea that’s helpful. Thanks. Now I just need to find the part numbers. I found the y-harness but can’t find the wiring harness that goes from station 1 to station 2. And I’ll need length since it’s going up the tower. I’ll try to give them a buzz in am and see if they can help.
