The Hull Truth - Boating and Fishing Forum

The Hull Truth - Boating and Fishing Forum (https://www.thehulltruth.com/index.php)
-   FELL Marine (https://www.thehulltruth.com/fell-marine-189/)
-   -   mounting surface thickness (https://www.thehulltruth.com/fell-marine/1112992-mounting-surface-thickness.html)

aa331 09-05-2020 06:37 AM

mounting surface thickness
 
Can someone tell me the maximum thickness of the mounting surface where the collar nut can still engage on the threads.

on a similar note, the installation instructions suggest using an adhesive to mount the unit if the surface is too thick. Has anyone done this, and if so, what did you use . is 4200 from the rear a good option?

Thanks

ajgraz 09-05-2020 07:44 AM

I went out and measured mine, with the collar nut engaged 4 full turns, it would mount in up to 1-1/2” thickness.

If I had to use adhesive, I’d use 4200. But I think you’d have to adhere on top rather than from behind. Without the collar, there’d be no mating surface in the rear.

aa331 09-05-2020 10:27 AM

got it

thanks

paul.petani@fellmarine.co 09-10-2020 11:05 AM

Hello,

Just to add as an FYI the portion of the Hub that is mounted is 1.9 inches long and the threads to mount the collar nut go all the way to the bottom. So mounting in up to 1-1/2" inches is correct.

All the dimensions of the Hub can be located on page 2 of the manual.
https://s3-eu-west-1.amazonaws.com/g...l-Multi_17.pdf

Thank You,
FELL Support


All times are GMT -7. The time now is 10:18 AM.

Powered by vBulletin® Version 3.9.3.8
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.