Go Back  The Hull Truth - Boating and Fishing Forum > BOATING FORUMS > Boating How-To’s : The Kerno Memorial Forum
Reload this Page >

Angler Boat Resource Thread - DIY's, Photos and Findings

Notices
Like Tree13Likes

Angler Boat Resource Thread - DIY's, Photos and Findings

Reply

Old 05-11-2018, 09:23 AM
  #941  
Junior Member
 
Join Date: May 2018
Location: FT LAUDERDALE
Posts: 5
Default

Originally Posted by the responsible asian View Post
i have a 99. how did you wire your electronics from the transom to the console?
actually now that i think about it i believe it is to the inside of the storage well not below it. can look later and advise.
DRAGGINBAITS is offline  
Reply With Quote
Old 05-11-2018, 09:29 AM
  #942  
Junior Member
 
Join Date: May 2018
Location: FT LAUDERDALE
Posts: 5
Default

Originally Posted by the responsible asian View Post
i tried squeezing the new nmea2000 style plugs through the hole in the battery compartment. would those fit?
yes that was what my new Simrad required, again very tight and i taped the heck out of it with electrical tape so not to lose it half way. helps to make the the tape to fish tape connection as much of cone shape as possible so pulls a little smoother but it takes some serious pulling.
DRAGGINBAITS is offline  
Reply With Quote
Old 05-11-2018, 09:31 AM
  #943  
Junior Member
 
Join Date: Jul 2017
Posts: 21
Default

Originally Posted by DRAGGINBAITS View Post
yes that was what my new Simrad required, again very tight and i taped the heck out of it with electrical tape so not to lose it half way. helps to make the the tape to fish tape connection as much of cone shape as possible so pulls a little smoother but it takes some serious pulling.
mine goes a couple inches through the hole then just comes to a dead stop and doesnt budge. do you know if that could be other wires or if its just the construction of the boat
the responsible asian is offline  
Reply With Quote
Old 05-11-2018, 09:40 AM
  #944  
Junior Member
 
Join Date: May 2018
Location: FT LAUDERDALE
Posts: 5
Default

Originally Posted by the responsible asian View Post
mine goes a couple inches through the hole then just comes to a dead stop and doesnt budge. do you know if that could be other wires or if its just the construction of the boat
there is a large amount of wires and also hydraulic steering tubes that run through. i believe they must have a tube that it runs through. were you able to run snake through from console to battery compartment?
DRAGGINBAITS is offline  
Reply With Quote
Old 05-16-2018, 06:26 AM
  #945  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Need more posts to add pics so I'll add brief description in the next few posts.
Bought my boat 3 years ago and dont regret it at all
I've made some changes and upgrades with a few more to come
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-16-2018, 06:29 AM
  #946  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Removed old chart plotter and depth finder and replaced with a Garmin echomap 7sv

upgraded four old 6.5 pioneer speakers with four 8" kenwood speakers and a kenwood amp. Also added 2 more 6.5 in rear of boat.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-16-2018, 06:31 AM
  #947  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Replaced old faded windshield, one of the biggest differences. Looks great.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-16-2018, 06:32 AM
  #948  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Removed bow rails and will be adding rod holders where bow rail screwed in.... gave the boat a more modern look.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-16-2018, 06:33 AM
  #949  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Replaced old halogen spreader lights with l.e.d. lights.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-16-2018, 08:01 AM
  #950  
Junior Member
 
Join Date: May 2018
Posts: 4
Default 220

Originally Posted by Miami_Sandbar_Sundays View Post
Replaced old halogen spreader lights with l.e.d. lights.
sandbar whats your cruise / wot / mpg with the 225's ?
POPEYES is offline  
Reply With Quote
Old 05-17-2018, 07:19 AM
  #951  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225

Wot 6000 rpm @ 45 mph
cruise 4200-4400 @ 30mph
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-17-2018, 07:21 AM
  #952  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225


OnlyMedication likes this.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-17-2018, 07:24 AM
  #953  
Junior Member
 
Join Date: Jul 2017
Posts: 21
Default

i have a 1999 22 cc with a 150 ocean pro. i bought it knowing that it would be underpowered, but does 30mph WOT lightly loaded sound reasonable? it has a few hiccups through the rev range so im trying to figure out if im even running on all cylinders
the responsible asian is offline  
Reply With Quote
Old 05-17-2018, 07:27 AM
  #954  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default 2004 Angler 22ft w/ yamaha 4 stroke 225




OnlyMedication likes this.
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-17-2018, 07:34 AM
  #955  
Junior Member
 
Join Date: Jul 2016
Posts: 15
Default

Originally Posted by the responsible asian View Post
i have a 1999 22 cc with a 150 ocean pro. i bought it knowing that it would be underpowered, but does 30mph WOT lightly loaded sound reasonable? it has a few hiccups through the rev range so im trying to figure out if im even running on all cylinders
what are your rpm at wot?
try a compression test to check your cylinders...fairly easy to do
Miami_Sandbar_Sundays is offline  
Reply With Quote
Old 05-17-2018, 07:36 AM
  #956  
Junior Member
 
Join Date: Jul 2017
Posts: 21
Default

Originally Posted by Miami_Sandbar_Sundays View Post
what are your rpm at wot?
5k give or take. i think i have a little room to play around with the trim and the pitch
the responsible asian is offline  
Reply With Quote
Old 05-17-2018, 07:43 AM
  #957  
Admirals Club Admiral's Club Member
 
Join Date: May 2016
Posts: 60
Default

What size / pitch prop?
Pkenn7 is offline  
Reply With Quote
Old 05-17-2018, 09:28 AM
  #958  
Member
 
Join Date: Aug 2015
Location: Charleston, S.C.
Posts: 83
Default

I wish my 22 WACC had the transom wells turned like that with seats like yours does. On my boat the wells are turned to run the length of the boat not leaving enough room for seats and just a waste of big open transom space.


SportsCar is offline  
Reply With Quote
Old 05-17-2018, 11:24 AM
  #959  
Junior Member
 
Join Date: Jul 2017
Posts: 21
Default

Originally Posted by Pkenn7 View Post
What size / pitch prop?
the current prop is beat beyond recognition but it came with a spare. the previous owner claims that its the same size and pitch. it seems to be at least the same size so I'll have to swap them out to know for sure. im just assuming its a 15 1/2 × 15 like the spare
the responsible asian is offline  
Reply With Quote
Old 05-18-2018, 08:57 AM
  #960  
Junior Member
 
Join Date: May 2018
Posts: 4
Default Rpm range

Originally Posted by the responsible asian View Post
the current prop is beat beyond recognition but it came with a spare. the previous owner claims that its the same size and pitch. it seems to be at least the same size so I'll have to swap them out to know for sure. im just assuming its a 15 1/2 × 15 like the spare
rpm range should be 4500 - 5500.
POPEYES is offline  
Reply With Quote

Thread Tools
Search this Thread
 
  • Ask a Question
    Get answers from community experts
Question Title:
Description:
Your question will be posted in: