Go Back  The Hull Truth - Boating and Fishing Forum > BOATING FORUMS > The Boating Forum
Reload this Page >

Turbulator Gasket - no risers - Do i need gaskets

Notices

Turbulator Gasket - no risers - Do i need gaskets

Old 01-14-2019, 04:09 AM
  #1  
Senior Member
Thread Starter
 
Join Date: Feb 2012
Location: CYPRUS
Posts: 194
Default Turbulator Gasket - no risers - Do i need gaskets

Hi
My 496 MAG base model doesnt have the 2 inch risers because four winns decided to remove them in order for the engine room door to close. Apart from the trubulator (#8M2000433) will I need any pair of gaskets (#27-862356) to be used between the manifolds and the elbows.
I mean the correct is A or B:
A .... Maniford - Gasket -Turbulator - Gasket - Elbow
B .... Maniford - Turbulator - Elbow

Also do trubulators need replacement or are reusable part?
koutroul is offline  
Old 01-14-2019, 07:04 AM
  #2  
Admirals ClubCaptains Club Member Admiral's Club Member
 
Join Date: Dec 2003
Location: Fort Lauderdale, FL
Posts: 6,435
Default

You need two gaskets per side, one between manifold and turbulator and one between turbulator and elbow, so A is correct. You can reuse the turbulators as long as they aren't chewed up at all (they usually are), but I would just replace them as by the time you scrape off all the old gasket material, you waste a lot of time and they are not that expensive.
sundancekid is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread