Notices

Shaft runnout question.

Old 05-25-2018, 03:00 PM
  #1  
Senior MemberCaptains Club Member
Thread Starter
 
Join Date: Aug 2006
Location: NJ
Posts: 490
Default Shaft runnout question.

I set up a dial indicator on my lower unit running as far out as possible before the splines. If rotate the shaft 360* the indicator shows a .010" swing. Would the runnout be .005" since a 360* turn is showing when the .005" "bend" is moving closer to the indicator and then when its moving away?
Mr.Mike is offline  
Old 05-25-2018, 03:55 PM
  #2  
Senior Member
 
Join Date: Jun 2004
Location: Raleigh, NC
Posts: 482
Default

Total indicated run-out is .010".

The .005" that you calculated is axis eccentricity. Basically how far out of concentric.
whalerboy is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread