1091LikesCrevalle 26 Open Special Edition Catastrophic Transom Failure.
07-08-2018, 06:59 PM
#1801
Admirals Club 
Join Date: Oct 2009
Posts: 517
Originally Posted by HOmer72
Contractor, without a doubt.
07-09-2018, 05:28 AM
#1802
Senior Member
Join Date: Jul 2009
Location: NC
Posts: 351
People forget the Midnight Express 5 motor boat that about lost the starboard 350 merc
Last edited by CapeFisher85; 07-12-2018 at 07:18 AM.
07-09-2018, 06:19 AM
#1803
Senior Member
Join Date: Mar 2011
Location: Pensacola, Fl
Posts: 676
Originally Posted by Lookinup76
I just want to know what line of work exists that allows you to have this kind of money to spend without needing to know how to spell even basic words in the English language?
07-09-2018, 06:31 AM
#1804
Junior Member
Join Date: Nov 2017
Posts: 19
OP, any updates on your boat?
07-09-2018, 07:10 AM
#1805
Senior Member
Join Date: Oct 2015
Location: Texas
Posts: 357
Originally Posted by Brocnizer1
watch the movie Idiocracy and you will fully understand
07-10-2018, 05:51 PM
#1806
Admirals Club
Join Date: Feb 2017
Location: Ponce Inlet, FL
Posts: 1,035
Originally Posted by opti99
OP, any updates on your boat?
07-10-2018, 06:16 PM
#1807
Admirals Club
Join Date: Nov 2012
Location: Charleston, SC and New Smyrna, FL
Posts: 519
Originally Posted by Muggin Mullet
Wish he would update the original post with periodic updates
07-10-2018, 06:29 PM
#1808
Admirals Club
Join Date: Aug 2014
Posts: 415
Originally Posted by CapeFisher85
People forget the Midnight Express 5 motor boat that about lost the port 350 merc
07-12-2018, 07:18 AM
#1809
Senior Member
Join Date: Jul 2009
Location: NC
Posts: 351
Originally Posted by MedicalManagement
did the transom fail and delaminate? Or did the mounting hardware fail? I'm asking bc I've seen the pic but never up close or heard what the cause was
07-12-2018, 09:44 AM
#1810
Admirals Club
Join Date: Aug 2014
Posts: 415
Originally Posted by CapeFisher85
The motor was through bolted to a plate to get it higher and the plate had studs welded to it to attach it to the transom. there were no through bolts directly holding the motor onto the transom. The studs sheared right at the plate and the motor was left dangling off one remaining stud and the tie-bar.
07-16-2018, 02:42 PM
#1811
Senior Member
Join Date: Oct 2010
Location: Panhandle, FL
Posts: 249
Helluuurrre.....
«
Previous Thread
|
Next Thread
»
