Go Back  The Hull Truth - Boating and Fishing Forum > BOATING FORUMS > The Boating Forum
Reload this Page >

Installed Bennett Tabs but have a question

Notices

Installed Bennett Tabs but have a question

Old 04-22-2017, 08:18 PM
  #1  
Senior Member
Thread Starter
 
Join Date: May 2014
Location: Louisiana
Posts: 358
Default Installed Bennett Tabs but have a question

I installed a set of Bolt 1212's on my Proline today. On the first actuator mounting, I didn't put 4200 around the outside area as in the picture. I did add 4200 to each screw & around the hole in the center for the wire. Should I remove the upper actuator and apply another coat of 4200?

Thanks
Attached Images  
Dago52 is offline  
Old 04-22-2017, 08:24 PM
  #2  
Senior Member
 
Join Date: Feb 2017
Posts: 1,830
Default

No
km1125 is offline  
Old 04-22-2017, 08:28 PM
  #3  
Admirals Club Admiral's Club Member
 
Join Date: Sep 2014
Location: Hinesville GA
Posts: 4,665
Default

Yes
Gnrphil is offline  
Old 04-22-2017, 08:37 PM
  #4  
Senior Member
Thread Starter
 
Join Date: May 2014
Location: Louisiana
Posts: 358
Default

Originally Posted by Gnrphil View Post
Yes
Should I clean out the mounting holes from the original 4200? I guess I can use a razor to remove the 4200 from the actuator.


Thanks
Dago52 is offline  
Old 04-22-2017, 09:23 PM
  #5  
Admirals Club Admiral's Club Member
 
Join Date: Sep 2014
Location: Hinesville GA
Posts: 4,665
Default

Originally Posted by Dago52 View Post
Should I clean out the mounting holes from the original 4200? I guess I can use a razor to remove the 4200 from the actuator.


Thanks
I would, Shouldn't be too bad as it's fresh. The fact that you questioned it leads me to think you'll just worry about it if you don't.
Gnrphil is offline  
Old 04-23-2017, 05:17 AM
  #6  
Senior MemberVendorCaptains Club Member
 
Join Date: Apr 2001
Location: The Tab Cave
Posts: 7,939
Default

Originally Posted by Gnrphil View Post
I would, Shouldn't be too bad as it's fresh. The fact that you questioned it leads me to think you'll just worry about it if you don't.
I agree with Gnrphil. One less thing to worry about, we write our instructions to follow what we believe to be best practices.

Tom McGow
Bennett Marine
Tabman is offline  
Old 04-23-2017, 08:28 AM
  #7  
Senior Member
Thread Starter
 
Join Date: May 2014
Location: Louisiana
Posts: 358
Default

Thanks. I removed the actuator this morning and caked it with 4200. Feeling much better now!! I hope to test everything out next weekend if the weather permits.

Thanks again
Dago52 is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are Off


Thread Tools
Search this Thread