kingsfisherman

well i believe I have the layout for my battery system basically figured out, I'm sure it's lacking a few things so I will post a drawing for suggestions.
Details are as follows:

Batt.1 = starting battery
Batt.2 = house battery
SW-1 = Blue sea 6006 single circuit on/off
SW-2 = Blue sea 6006 single circuit on/off w/ MRBF 2 term. fuse block on load side
SW-3 = Blue sea 6005 single circuit on/off w/ removable key
ACR = Blue sea 7610 SI series
Safety hub 150 fuse block
pwr post is for kicker motor connection

there are a few things I'm not sure about:

1. should the ACR be connected directly to the batteries and not through the switches?
2. if I isolate the start battery and tie in the house battery for starting how does that affect the ACR?
3. where do I need more fuses for the 7" rule?

thank you for your help.