How to lengthening a 5/8" id fuel tank vent hose
07-06-2020, 08:19 AM
#1
How to lengthening a 5/8" id fuel tank vent hose
I would like to create a loop in my 5/8" ID fuel tank vent hose and need to lengthen it by about a foot. Does anyone know of a fitting I could place in line to do this?
07-06-2020, 08:22 AM
#2
Senior Member
One of these, available at finer Home Depots everywhere.
07-06-2020, 09:06 AM
#4
Senior Member
Barbed hose union.
07-06-2020, 10:41 AM
#5
Senior Member
Originally Posted by sea hare
Thanks, that's what I'm looking for, what is it called?
And is there such a fitting with a 90 degree elbow?
And is there such a fitting with a 90 degree elbow?
Gerald
07-06-2020, 01:53 PM
#6
Admirals Club 
I just bought a couple of those.
07-15-2020, 06:16 AM
#7
thanks everyone
I found the 90 degree barb, 5/8" inside diameter, online at Amazon, ordered it on Sunday, had it on Monday. Had to buy two, for $10 including free delivery. Saved a bunch oh time running around to stores to look for it so I didn't mind too much having to buy two when I needed one.
Neither Home Depot nor my local commercial plumbing supply house had it. Plumbing supply house had 1/2 " and 3/4" id in stock, but not 5/8".
I found the 90 degree barb, 5/8" inside diameter, online at Amazon, ordered it on Sunday, had it on Monday. Had to buy two, for $10 including free delivery. Saved a bunch oh time running around to stores to look for it so I didn't mind too much having to buy two when I needed one.
Neither Home Depot nor my local commercial plumbing supply house had it. Plumbing supply house had 1/2 " and 3/4" id in stock, but not 5/8".
