View Single Post
Old 02-12-2017, 08:04 PM
Join Date: Jun 2015
Location: Moncks Corner SC
Posts: 89
Likes: 0
Received 0 Likes on 0 Posts

Had some time today to go to the boat and take some measurements for the main run of wire from the motor to the console where the batteries will be installed. I also had time to go through the rats nest of wires and label everything, much easier than I was expecting. I'm going to leave the motor, ignition and trim tab harnesses alone as they look and work fine though I am going to install a wire run tube to get them all off the floor. I had a few more parts come in though they were all lighting related. Will be ordering some more new stuff within the next few days.

What I am working with
Attached Images