View Single Post
Old 11-13-2015, 05:10 PM
Admirals ClubCaptains Club Member Admiral's Club Member
THT sponsor
Join Date: Jul 2005
Location: Miami Fl / Washington NC
Posts: 2,037

Cutting the P.O for electronics Monday. Note to self; "Must have console completed".

Certainly our molded T top pipe to console interface is a wee bit more work than dropping the boat off at the pipe welder for a bolt on solution. When each poling platform on the flats boats I used to build had four 1/4-20's for each leg, I had my own die made to make a special isolating bushing the fit the countersunk holes in the base pads.

It solved the SS to Aluminum corrosion issues but now I don't like to see any fastenings at all if possible.

Note to self; "Exception, use six big ones to hold the 350 Verado's to the transom".
Attached Images    
Otseg is offline