View Single Post
Old 11-12-2015, 03:45 AM
  #492  
Otseg
Admirals ClubCaptains Club Member Admiral's Club Member
THT sponsor
 
Join Date: Jul 2005
Location: Miami Fl / Washington NC
Posts: 2,037
Default

I made several illegally wide load dump runs yesterday to dispose of limited production tools (LPT molds) we were obligated to store for two years after building the parts. (Any one in the shop who was willing to drive the load except me probably doesn't have a drivers license) I tasked a crew to organize one of our buildings this week to make a shop for final finish.

Will plan to pull the boat out from the main shed for a picture before thanksgiving.

We have the 350 Verados in hand and will do a pre fit before final finish and rigging.

I have had about $300 dollars of fittings for the sea chest and bait-well plumbing on my desk for a couple weeks and have been mixing and matching to simplify. I get a credit at Port Supply for every one I moved to the no go side of my laptop.. :-) Right now, not including the 4 pumps, the sea chest assembly is less than a few pounds each side. Only could be lighter if we used a bucket. May not take a picture of that!
Otseg is offline