The Hull Truth - Boating and Fishing Forum - View Single Post - 05 DF225 WOT issue
View Single Post
Old 06-14-2019, 05:37 AM
  #1  
linesider04
Senior Member
 
Join Date: Oct 2008
Location:
Posts: 112
Likes: 0
Received 0 Likes on 0 Posts
Default 05 DF225 WOT issue

I have a question regarding the the WOT position. I achieve maximum RPMs but still have and an inch or tow of throttle lever left. Moving the throttle those last 2 inches of travel results in no additional RPMs of change in motor noise. It appears to be doing nothing. I have checked to the best of my understanding that the cam alignment mark is in the center of the cam pin as shown in the manual. Also The neutral stop and wide open stops on the throttle body and/or air intake are correct. Also butterfly is in fully open position at full open throttle. Is there anything else I could be missing? I have checked the fuel line from the the tank pickup to the low pressure fuel filter. All filters have been replaced including VST screen. Anti siphon valve was removed also. Possible fuel pump issue or faulty TPS? Not showing any codes or alarms. Just seems like I'm leaving some performance on the table. Other than this issue the motor runs great.