mtpleasantmako

would like to install bennets on above boat. i have (new) v351hpu1 and two (also new) 13" actuators(?). please excuse my loss of proper terminology. what other parts would i need. obviously two tabs. i have looked in some catalogs and have not seen those sold separately. what about wiring, fasteners, hydraulic lines, switch? also is what i have overkill? picked them up at a yard sale for fifty bucks. thanks for your advice. the site is great and i will make use of the information provided in previous threads.

Tabman

Basically you will need the following:

2 each TPA129 Trim Plane Assemblies
1 each H1170A Hardware kit (contains all the fasteners and plumbing parts for the kit).
1 each WH1000 22 ft wire harness
1 each T1125-20 20 ft hydraulic tubing
1 each RS1000 rocker switch

Most dealers will be happy to order these parts for you.

Given the parts you have this would make an appropriate kit for a Mako 17.

Here is a link to our parts page.
http://www.bennetttrimtabs.com/partprice.htm

I hope this is helpful.

Tom McGow
Bennett Marine