Mounting bracket - The Hull Truth

goofy2me · 06-18-2007, 08:40 PM

Hi Tom, just got a set of trim and missing some parts. I am in need of a mounting bracket (H1179), and the lexan cover (vp1138) for a V351. Can you provide me a no. where I can order these parts? One other question is when you mount the tabs on the boat, should the actuator be fully out or in before making my marks to mount to the transom? Where is a good place to mount the trim? I have a 1999 Bayliner Trophy WA 2002. Any help will be appreciated. Thanks again.

Tabman · 06-19-2007, 11:02 AM

I am out of the office today, send an e-mail to MJthomas@bennetttrimtabs.com include your address and the parts you need and he will be delighted to send them to you, no charge.

The actuators will be fully retracted when you mark the transom. They are full retracted by default when they are not hooked up to the system, there is a spring inside that pushes the piston fully up when there is no hydraulic pressure in the system. The bump can usually be mounted aft in one of the compartments near the transom on that boat.

I hope this helps,
Tom

goofy2me · 06-27-2007, 11:07 PM

Want to Thank You for the parts and your help. Also just got me the nmea1 for it to. Looking forward to install it and to see if it is as good as everyone say it is

. Thanks again

Tabman · 06-27-2007, 11:34 PM

Great, glad we could help!

Tom