molded plastic suction cup

[C Skip R]

does anyone know where you can purchase a molded suction cup with molded ring for attaching flatline clips to. i have seen the aftco flat line clips with 3 suction cups but this is just the suction cup molded so you can attach things to it. have seen them in costa rica on sportfishing boats.

[t_bare]

I have gotten those at a craft store, they were marketed as wreath hangers for glass doors.

Good Luck
t_bare

[Drifter]

link: http://www.finestkind.com/cgi-local/...20QUICK%20CLIP

Looks like the clip is held in place by screws. You might could remove the clip and replace if with a snap swivel (with one of the screws) if you're looking to attach someting else...

[awl-me]

just get the ones from a hardware store, take the metal ring hooks off and crimp release clip on with 400 pound mono by crimping mono to one cup around the plastic circle ridge on top then put mono through blacks release clip and crimp to a second cup as u did in the first one

[Ice Cream Man]

Have you tried looping a # 64 rubber band around the rod handle - or is that not low enough?.......ICM

[pschwart00]

Use the suction cups designed for holding down boat covers - very strong!
http://www.basspro.com/servlet/catal...=SearchResults

OR:
http://www.basspro.com/servlet/catal...=SearchResults