NMEA Wiring - Simrad AP28- Furuno FCV 1100- Northstar 6100

[OUTBOUND44]

Hey Guys, I am right there with my install just need to finalize my NMEA wiring. The AP 28 was a breeze to install and works like a charm.

I have the 6100 & the AP28 wired together, but I can't figure out how to get the waypoint name or number to show up on the AP28 once in nav mode. I am not sure if this is a problem with the NMEA wiring or a setting in the 6100 or AP28.

What I would like to do, but have been unsuccessful is wire the 6100 to the 1100 so I can output position data, as well as output speed data from the 6100 to the 1100.

Does anyone know if I can output depth data from the 1100 to the AP28 without a smart transducer?

My next project is to prime and paint my mast since it's fabricated. Once that's done I can install it along with my radar.

Bill