Just got my LMF 400 today. I also ordered the trim tab sensor. I hope to install both this weekend. I bought everything from Jim at BOE. I know it has been said here 100 times but he is truly a class act. If you have not done business with him you are missing out. His prices are cheap and customer service is second to none!
Now for my question. I am going to put this on the Contender because the Yamaha guage is acting up. I have 3 tanks and 2 motors. There is not an option in the manual for this. Anybody ever done it? If so how did you set it up? I only have the fuel flow meters no tank level measurement. (getting to those is going to be a pain! I will have to remove the floor) The maunal says I can do: 1Eng/ 1 Tank, 1 Eng/2 Tanks, 2 Eng/1 Tank, 2 Eng/ 2 tanks, 3 Eng/1 Tank or 3 Eng/ 3 tanks.
The starboard and port tanks are both 45 gallon and the center is 160 gallons. With the valves I have avialble I can run the starboard motor off of the starboard tank and/or center tank and the port off the port and/or center. I can not run the starboard motor of the port tank or visa versa.
So how do I set this up??
I will post this is the BOE section as well.
THT sponsor
Another lmf-400 setup question 
