Starboard/Seaboard Cuddy Doors?

[Forbein11]

My plexi cuddy doors scracked down the middle when a buddy hit one during a rough ride. Can a quality replacement be made out of 1/4" sae/starboard? Also, if so, where would one look to find this product locally? I live in Hopedale, MA. Thanks in advance for the help.

[jbutah3000]

Try these:

http://www.buckwoodcraft.com/boat_doors.htm

updplastics.com

[trollme]

jbutah3000 - 7/25/2007 11:18 AM

Try these:

http://www.buckwoodcraft.com/boat_doors.htm

updplastics.com

What he siad.
Good stuff,thats what I'm using On my Bertram project.

[frank1861]

Yes you can I had that done after I broke the cuddy doors on my dad's last boat. I brought in the pieces and a company in tampa made them for me in I believe 3/8 for a little over a hundred bucks.

[Forbein11]

Thanks for the replys. Seems like starbooard came make a fine cuddy door.

Frank1861, was that $100 cost including the fabrication? Thanks again.

[frank1861]

It was to copy the doors themselves which included fabrication and materials. They copied them perfectly pre-drilled the holes for all the mounting hardware and hinges.

[Forbein11]

Thanks for the help. I found a local co that will cut them to size for me. All I'll have to do is screw on the hinges. Total cost $45 for 2 11.5"X32.5" pieces. Can't wait to get them in. It'll no longer be a duct tape job.