carol1 - 4/23/2007 9:20 AM |
My mechanic bleed the oil system and installed a new oil lift pump on the 2003 250 HP ficht ram.
I took it out and after 15 minutes and at 4,100 rpms the no oil light came on.
What else could it be?
Did the mechanic test the oil pressure after installation to make sure it met specs and that the regulator was working correctly? Did he test the oil alarm system to come on at the correct psi? Did he inspect the oil tank, pickup filter, hose, primer, fittings, etc. also? Did he bleed or "burb" the pressure sensor to make sure there was no air blockage? Did he inspect the sensor connector to see if any oil contamination is causing false alarms?
Does squeezing the oil primer ball make the NO OIL light go out?