Birdsall,
I need some custom brackets to raise my two F150s up a few inches.
Because of my transom configuration, none of the off-the-shelf models will work. I've contacted everybody I can think of (Bob's, CMC, THMarine, even Jay from Black Lab), but they won't/don't do this sort of thing.
Here is a shot of my transom. You can see the motorwell drains and scuppers are very close to the engines. The rub rail I could modify if needed.
TH Marine makes the closest thing to what I have in mind.
However, theirs is designed so that the pieces are installed like this (Excuse my bad ascii art. Ignore the -, they are only for spacing.):
__transom__
--[------]
---engine
To fit my transom I need something like this:
__transom__
---]-----[
---engine
Or I could go for something like this:
__transom__
---______
---_|__|_
---engine
I think with a little reinforcement welded between the two pieces, it would be plenty strong and not buckle.
Here are the specs I'm looking for:
- 3-4" lift. No adjustments necessary.
- Minimal setback. 2" would be good, 4" would be absolute maximum.
- 3/8" or 1/2" 6061 aluminum (this is what all the manufacturers use and their products support engines up to 225+ hp).
Can you guys do this?
custom jack plate?
