The Boating Forum - Flowscan Question
THE HULL TRUTH is the world's largest FREE network for the discussion of Boating & Fishing. Whether you're researching a new boat, or are a seasoned Captain, you'll find The Hull Truth Boating & Fishing Message Forum contains a wealth of information from Boaters and Sportfishermen around the world.
Adios
07-08-2005, 08:23 AM
I have a single gauge flowscan for twin outboards. The port side will show the RPM and calculate engine hrs. but will not show fuel consumption (shows 0.0). This has happened before and it seemed to fix itself (which leads me to believe it is something simple). It doesn't want to fix itself this time. Starboard Side works fine. (I just 2x that reading to get a rough est.) Any ideas on where to start would be greatly appreciated.
WildeOne
07-08-2005, 09:31 AM
Check the flow meter wiring from that engine ... sounds like a poor connection or broken wire somewhere. Also, FloScan tech su[pport is excellent. Call or email them if you don't get it right quick.
ubettcha13
07-08-2005, 11:32 AM
just rewire that side with new wire and be careful not to pull to hard when routing it back through